Electronics Forum | Fri Oct 17 04:23:51 EDT 2008 | fujiphil
Check the image using the fast inching [F] and axis selection [2]. After vision error, press [F] then [2]. The monitor will display a binary images. You will now have a visual look on how the error occurs. Adjust the CCD level of the camera until you
Electronics Forum | Fri Oct 17 06:24:44 EDT 2008 | tegel
Hi, When you tried vision type 254, did you change the size of the body? On 254 the body size should be the outer dimension of a component, so on a PLCC (or any other component) the leads should be included in the body size as well. One other thing r
Electronics Forum | Mon Jul 11 10:48:48 EDT 2016 | mnorthey
I have experienced this problem on a number of different machines and have found that it has been one bad nozzle causing the problem. We run Juki 3010 and 3020 and occasionally we have had similar problems. One question, is it bad placements on all 6
Electronics Forum | Mon Jul 11 10:59:50 EDT 2016 | mnorthey
Other problems on previous machines that we have experienced is that there was not enough board support under the panel or that the panel thickness was inaccurate. Both situations can cause parts to bounce off the PCB or not to be pushed into the pas
Electronics Forum | Tue Jul 12 10:33:24 EDT 2016 | dontfeedphils
I'd start by checking and reteaching the nozzles (this is automatic, it'll measure the nozzle length and vacuum values for each nozzle). After that double check the value you have entered for the PCB thickness as this will impact where the machine t
Electronics Forum | Tue Jan 16 12:14:35 EST 2018 | emeto
There is no reason why you can't see these leads clear. Isn't there any way you can play with the lighting? I used to have Siemens machines and I want to say that it was possible. Go on the machine, start editing this shape code and find where you ca
Electronics Forum | Wed Jan 17 07:08:50 EST 2018 | emeto
Yeah, your machines are probably even older generation. I can tell you that what you can see is always more clear than what the machine can see(worked with 10 brands and probably 30 models). If you don't have good lighting and camera, some parts jus
Electronics Forum | Wed Jan 09 05:21:07 EST 2019 | jrogalski88
I will try this, thank you! Out of curiosity what about an 0807?? currently using an 1140 but there's still issues with that. I'm almost wondering if maybe parts just aren't sitting flat in the pocket so I'm getting pick and visioning issues.
Electronics Forum | Wed Jan 09 11:46:45 EST 2019 | bane016
Maybe you have to contact your machine support they can modify special nozzle for that component...i dont know what else you can try...or just contact your support and ask them what to do...we had a similar problem with LED diode on our machine..and
Electronics Forum | Wed Oct 15 15:08:05 EDT 2008 | mbrunton
I have a Fuji IP1 using the MCS control system. Everything works fine, but it seems to have tons of problems placing PLCC4 parts (Osram Power TopLED). Some reels I load up it will give a vision processing error for about 1 out of 10 parts. Other r