Electronics Forum | Wed Mar 30 11:59:56 EDT 2016 | cbeneat
Our company has 8 EKRA X5-X5 Pro's we do not use that function on any. Personal preference I guess. I assume the cartridges are set up like the pneumatic gun type dispensers, drop in a cartridge and go. Not in Europe, sorry no knowledge of where t
Electronics Forum | Tue Mar 27 16:57:41 EDT 2018 | warwolf
You could try changing the SMC pneumatic cylinder? We had a few that needed them replaced, we would get a pick error from them and the part would not be presented in the tape pocket (as if the tape doesn't push far enough to click over the ratchet s
Electronics Forum | Tue Jun 12 20:54:34 EDT 2018 | dekhead
I don't recall a "Heavy Pallet Rails" option in software; I believe you need to change the Remote Board Stop to "Not Fitted" and move the pneumatic and electrical (BSK6)connections to correspond with the camera mounted board stop. Pretty well detaile
Electronics Forum | Tue Sep 22 14:33:41 EDT 2020 | majdi4
Thank you @Makersan CO for your input . Am still doing research for a best tool choice.. I want to avoid pneumatic supports because i had bad experiences with it..am looking for magnetic base supports involved in a dynamic movement block .. or someth
Electronics Forum | Wed Apr 28 17:45:14 EDT 2021 | mishafockin
This is a very tricky question butt... we should be able to afford up to 200k for a full line (printer/PnP/inspection/oven) I know the cost of feeders will be very critical but looks like the good old pneumatic not cutting it anymore.
Electronics Forum | Tue Jan 30 15:12:56 EST 2024 | oxygensmd
We have 3 of them. E5 (2000), X5 (2006), X4 Proffessional (2012). All of them can handle our requirements, even E5 have the requested accuracy. X5 have disk PCB clamping which really nice for the operators and X4Prof have SPS (3-stage) witch pneumati
Electronics Forum | Wed Dec 20 17:33:00 EST 2000 | Travis Slaughter
I don�t have the answer for you but it would not be difficult to make a fixture to find out. Combine a counter, pneumatic cylinder, and a solenoid in such a way to do the job for you. Cylinder pushes the card into the connector, when contact is made
Electronics Forum | Thu Mar 01 09:14:06 EST 2001 | Dale Dolan
Dek 265 Get yourself Formflex tooling for quick changeover time. The principle being tooling pins are raised by a combination of pneumatic's and hydraulics to meet the underside of the pcb which rises to print height. No longer will u have to judge
Electronics Forum | Mon Mar 26 15:50:57 EST 2001 | jsmith01
Does anyone know who makes, or were to get a finger-actuated switch for a pneumatic dispenser? I used one years ago at a different company but for the life of me I cannot remember who makes it. I have looked in the typical places - Contact east, Te
Electronics Forum | Fri Jan 28 15:50:22 EST 2000 | Mike Naddra
Is anyone placing 50mil pitch BGA's from a matrix tray, with a Fuji Ip2. The Issue I have is the transfer from the MTU when the part is being transfered for placment it is picked from the tray and then placed on the pneumatically actuated transfer wh