Electronics Forum | Mon Jun 16 11:36:28 EDT 2014 | bobpan
Are both red and green leds on for the driver cards (they are located in the bottom right of the machine). If they are both on then you have an interlock opened. If this is the case....check the side doors....sometimes they are not shut all the way.
Electronics Forum | Fri Aug 30 10:50:47 EDT 2013 | bobpan
Clear the memory again and try to input by handheld the modcodes 1 by 1 and see when the problem happens. You can input a number then press home and home. Sounds to me like a number is incorrect but its hard to tell. Are you sure the file that you ar
Electronics Forum | Tue Sep 03 05:37:06 EDT 2013 | bobpan
It sounds like your dispenser has a problem....The default mod code for 56 is 0 (this should be off). Thats why when you cleared the mod codes the machine was able to home. When you reload your saved mod codes it is probably set to 1. The machine wil
Electronics Forum | Fri Aug 30 21:54:14 EDT 2013 | nophsem
Well, the error occurs with Mod Code 56 (dispenser enable). Head # 1 has installed this accessory, but we use it very little and it wasn't this time. I probed setting 0,1,2 and 3. I downloaded Mod Codes from controller to assembler, then the error b
Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan
I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse
Electronics Forum | Fri Feb 01 07:21:32 EST 2019 | dfl
One of my 8mm feeders is blinking the red led after the pick-up. With both buttons the motor works as expected (forward/backward), but after the nozzle pick-up the motor moves forward and then the red led blinks. pressing the buttons the green led l
Electronics Forum | Sun Feb 03 07:39:27 EST 2019 | dfl
POCKET POSITION PROGRAMMING This procedure ensures the components are properly centered at the tape feeder pickup point (over spring stabilizer). NOTE: The feeder can be reset at any time by removing it from the feeder base and reinserting it. This
Electronics Forum | Wed Jul 06 08:02:54 EDT 2011 | jholif
bought the cable replacement kit and replaced all of the ribbon cables and still the deadly motor error 4. Everything in the system has been replaced except the X motor and the Y motor cable.
Electronics Forum | Thu Jun 30 14:25:42 EDT 2011 | bobpan
x and y ribbon cables would be my first guess...... good luck
Electronics Forum | Sun Dec 04 15:42:21 EST 2011 | ngineer
Thanks for the reply bobpan. I had the motor power on. I did have a side panel that was not shut all the way. Once I shut that, the error went away and it made it through its startup sequence. No errors. Thanks for the help.
