Electronics Forum | Tue Apr 22 05:38:56 EDT 2003 | mk
This sounds like a job for ssd. No pad shapes to worry about. Look into http://www.sipad.net and please contact me off line to discuss it. Matt Kehoe mkehoe@sipad.net
Electronics Forum | Tue Dec 31 02:10:04 EST 2019 | sssamw
It looks like solder dross there or flux residue that not activated well. Your speed is 43cm/60s, wave width contact is 2cm, so dwell time is 2x43/60=1.43s, it's short also.
Electronics Forum | Sat Jan 18 12:44:35 EST 2020 | anteiv
We made much better contact of wave with board. There was not enough solder in bath. We increased it so wave height is higher with same pump power And now board is pushing dirty wave to the other side and board is much cleaner!
Electronics Forum | Fri Aug 29 10:38:49 EDT 2008 | patrickbruneel
Look at this article http://circuitsassembly.com/blog/?p=191 The EU commission totally lost contact with the real world.
Electronics Forum | Mon Dec 02 16:01:15 EST 2002 | russ
If you can, attach athermocouple to the locations where you are getting solder balls. A previous product I had showed the same thing and we found that we had inadequate preheat leaving the liquid flux to splatter when it hit the wave. It could aslo
Electronics Forum | Sun Aug 07 13:12:45 EDT 2005 | Patty Chonis
Hello We sell soldering stations that can heat up to 200 celcius in less then 20 seconds. The temperature settings are variable and can be pre-programmed. The stations are very competitively priced and can handle home soldering applications. Please
Electronics Forum | Thu Jun 07 18:09:21 EDT 2007 | stephan
We noticed unsufficient soldering on some 0805 chips located between pins from a plastic bloc connector . All chips are soldered with 45� angle. Flux quantity , preheating , contact time and PCB quality was checked. Do you know any international stan
Electronics Forum | Mon Jan 19 09:49:20 EST 2004 | davef
Not as such. Choices are: 1 Cut and epoxy some board foil from your board fabricator. 2 Sacrifice part a pad repair kits from the likes of: * Engineering Lab 905-785-1982 * Circuit Technology Center 978-374-5000 * General assembly suppliers catalog
Electronics Forum | Tue Aug 13 23:09:25 EDT 2019 | action_101
The best one is NOT one of the guns that the sales reps had to be deceiving to get their promotional pitch in without being up front on who he was or the other rep who tried to capitalize on the other A-holes deceiving tactics.... RIDICULOUS Contact
Electronics Forum | Tue Dec 31 02:33:57 EST 2019 | anteiv
thanks again for reply, we have now configured speed of traveling so pcb can travel through preheat with one speed (call it v1) and through wave with other speed (call it v2). Lenght of preheat elements is fixed, so with speed v1 we can change pr