Electronics Forum | Mon Aug 06 11:42:17 EDT 2007 | slthomas
Because our method for providing power to the stick feeders is clunky and temporary and with FES carts we want it out of the high traffic area.
Electronics Forum | Fri Aug 17 07:53:26 EDT 2007 | mmjm_1099
I got more detailed into this. It seems the operators only need to do a pick offset of 2mm on the stick feeders.
Electronics Forum | Thu Jul 08 02:32:47 EDT 2010 | tivux
I soldered a wire in the tape press lever of th feeder, so as to create a small gap where the cover tape passes and the component doesn't: in this way the component is pushed down in the pocket as soon as it tries to follow the cover tape. regards,
Electronics Forum | Thu Jul 08 09:38:26 EDT 2010 | fredc
Could this wire be helping by a second means, becuase it is grounded to the feeder it may be discharging the static at the point it is being produced? If so it could be bent to contact the film and not scratch the LED lenses.
Electronics Forum | Thu Oct 07 16:55:19 EDT 2010 | cbroegger
Hi, This one should be for the TSSOP16 and up to TSSOP20 : 00343788-02, check the attached pdf.
Electronics Forum | Fri Oct 08 04:08:37 EDT 2010 | walkbury
Thanks for the reponse.... really appreciated. Just checked pricing with Siemens UK.... Get this.... they want £405 each!!! I'm in the wrong business!!! Anyone know of an alternate source for these parts? Best regards Gary
Electronics Forum | Fri Oct 08 07:04:19 EDT 2010 | roycet4
Try making your own out of the IC tubes.. I used to do this all the time when I was using Siemens. Not as good as the metal slides from Siemens but it will work good enough..
Electronics Forum | Thu Jan 14 15:44:20 EST 2016 | sssvajunas
Hello, after we finish project (mydata) we unload tape from feeder and place a stick on the edge of tape. Maybe somebody can help with alternatives to this? (plastic clips) becouse then unloaded tape is used for another project it is sticky
Electronics Forum | Thu Aug 15 10:51:20 EDT 2024 | dontfeedphils
Are you able to slow down the feed rate? Are the parts possibly sticking to the cover tape a bit when it's peeled back?
Electronics Forum | Thu Aug 09 15:54:12 EDT 2007 | jimmyjames
We have the same problem at times but our feeders tend to move to the back when we want them on the front. We have Opal machines but all the software should be the same. (assuming you have the offline programming/optimization software, AMS) What yo