Electronics Forum | Fri Oct 08 17:12:31 EDT 1999 | Dave F
| Hi, | | Does anybody know what is the minimum gold plating thickness on the PCB goldfinger required by the industrial specifications - IPC, Bellcore, etc. Where can I find the information? Appreciate for the help! | | Thanks, | Tony | Hi Tony:
Electronics Forum | Wed Oct 07 03:34:11 EDT 1998 | Thomas Blesinger
I am trying to find out, what possibilities I have, to print solder paste on a board, when the task is to have 120 Microns thickness for the biggest part of the board (85% of the real estate), and then have 250 Microns of thickness on the remaining
Electronics Forum | Mon May 18 13:18:25 EDT 1998 | Chrys
I'm reviewing my board fab spec. It calls for a minimum SnPb thickness of 50 microinches on HASL PWB's. I've looked at other specs that call out anything from 30 to 80 microinches, and others that just say the copper pad must be covered and soldera
Electronics Forum | Tue Oct 07 08:38:05 EDT 2003 | davef
J-STD-001C requires removal of gold from (through-hole) component leads when the thickness of the gold layer is above 2.5 microns to prevent problems with embrittlement. The thickness of gold on an ENIG board typically is around 0.05 micron, resultin
Electronics Forum | Mon Jun 14 14:39:12 EDT 2004 | davef
HASL Thickness: * HADCO DFM manual specifies a nominal thickness of 50-1500uin with an option for 100-1000uin * Merix DFM manual specifies 30-200uin IPC-6012, Class 1, 2, 3 do not spec a HASL thickness at all but only require that full coverage is m
Electronics Forum | Tue Jul 27 06:08:18 EDT 2004 | C Lampron
Good Morning Everyone, Could someone please tell me what the acceptable range is for HASL plating thickness. We have some raw boards with plating thicknesses ranging from 3-4 mils on a fine pitch QFP. We are expeiencing bridging at this location an
Electronics Forum | Tue Aug 17 13:24:47 EDT 2004 | blnorman
We have parts that have electroplated tin over nickel. The mfg. assures us the minimum thickness of the tin is 5 microns. Cross sections have shown many instances of 1 micron and pits that go down to the nickel barrier layer. A request for thicker
Electronics Forum | Tue Apr 12 19:31:39 EDT 2005 | davef
Tell your fab that you'd like your ENIG according to IPC-4552. Just so that you know, IPC-4552 ENIG specification: * Ni thickness: 3 - 6 microns [120 - 240 microinches]. * Au thickness: 0.075 - 0.125 microns [3 - 5 microinches]. * Recommended spec
Electronics Forum | Thu Jun 09 07:02:02 EDT 2005 | ajaydoshi
1. We do have PCB with 0402 component, Micro BGA ( 0.5mm pitch , 0.25 mm pad size ). PCB thickness is 0.8mm. What stencil thickness we should use. PCB size 40 mm X 60 mm 2. We have EKRA E4 , What will be optimum setting for above. Pressure, Scquge s
Electronics Forum | Tue Jul 19 12:03:34 EDT 2005 | cyber_wolf
CLampron, There is no place for PCB thickness in a Mydata program. The board thickness is of no consequence.(As long as the thickness is uniform across the entire board) When you run a program, the Z axis touches the surface of the board to determin
