Electronics Forum | Wed Dec 15 01:25:14 EST 1999 | Bubba
Larry, What has been removed from the machine lately. Most bearings don't just fall apart while running without giving some type of warning. My experiance with LM bearings is they usually don't just fall out, most cases the bearing block was removed
Electronics Forum | Thu Nov 11 18:28:10 EST 1999 | John Thorup
Hi Jeff Actually it's not necessarily Signal to Noise Ratio or even RF circuitry. All no cleans leave behind residue by description. This residue can affect RF or other high frequency circuits in a number of different ways including SNR. Very high
Electronics Forum | Wed Nov 10 12:13:53 EST 1999 | Wolfgang Busko
That�s what we consider to be practical if the 20% were the worst case we see but the reality looks different. By chance we get a -20%, sometimes worse, sometimes a "good" 10%, rarely does it hit the nominal value and never it�s a +%. In short: It lo
Electronics Forum | Mon Nov 08 11:01:12 EST 1999 | Brian Larson
We are leaving 12-18 thousands material when scoring. Several components are cracking during depanelization. The pizza cutter machines out there are either too expensive or too slow to solve our problem. I am looking for a magical solution. In case
Electronics Forum | Sat Nov 27 10:16:38 EST 1999 | Steve Thomas
The new design resulted in much better release characteristics. We are quite satisfied. By the way, he says he can cut dead nuts 90 degree walls on the apertures, or traps. I didn't ask what the wall angle was, nor have I seen any recommendations,
Electronics Forum | Thu Oct 28 04:52:27 EDT 1999 | Paul Gerits
Hi Jerry, normal proces would be; 1st. reflow side (top) 2nd. curring side (bottom) 3rd. insert 4th. solderwave Reason for this is that you have a better handling and no overdue stress to components in case you do bottom before top. It is also eas
Electronics Forum | Wed Oct 20 05:13:24 EDT 1999 | Paul Gerits
Hi Jorge, As you know SMEMA is a world standard (means it is the same at every vendor and each machine), at DEK you can buy (if not already implemented in your printer) SMEMA communication option. This is a pcb which is set in the machine to enable
Electronics Forum | Wed Sep 29 22:48:07 EDT 1999 | Dave F
| Can someone help me find info on gold repair? I know it can be done, but I need to know how expensive it is, etc. | Paul: The following seel gold finger repair kits, in-case you haven't had your dose of heavy metals: Hunter Products 792 Partridg
Electronics Forum | Sun Sep 26 11:54:06 EDT 1999 | Earl Moon
| i had a problem here, during the wave soldering process, we apply a water soluble mask on the gold finger to protect it from contamination. But after washing, there is still some mask left on the gold finger. | Can anyone pls advise is there any pa
Electronics Forum | Mon Sep 13 02:46:19 EDT 1999 | dreamsniper
I noticed that some of our pcb's component legend/designation are unreadable as they are placed under smt pads. Is this correct and according to standard? Although we don't have any problems with them as of now, I would like to know the effects on th