Electronics Forum | Tue Dec 25 05:26:43 EST 2018 | premkumar_haribabu
Hi Robl, Thanks for quick reply , I want to see you my attachment first ( forgot to attach in my first share ) .As i said earlier ,Im suspecting termination design made by vishay & I never seen these kind of design from other alternate vendors which
Electronics Forum | Sat Dec 22 01:34:26 EST 2018 | sara_pcb
My BGA is 0.5mm pitch with Sn66Pb36Ag2 ball. My PCB finish is HASL. Want to do reflow using Eutectic Sn-Pb reflow paste. My Assembly is IPC Class 3 product. 1. Is there any long term reliability issues with 2% Ag in BGA Ball. 2. If the PCB finish
Electronics Forum | Sat Jan 12 11:47:25 EST 2019 | ranap121212
I am looking for a good material for selective nozzle. We are currently using Kovar but it is expensive and wears out it has very good wetting properties.I looking for a material or coating that would allow me to keep the binder flow and with less co
Electronics Forum | Sun Jan 27 17:59:25 EST 2019 | bobpan
The y-axis on that machine is left to right. If this is the axis you are having a problem with....check the motor. I have had to tighten the tension on it before. If you notice you lose steps after running for a while then this is going to be the iss
Electronics Forum | Mon Jan 28 13:40:53 EST 2019 | liquidspacie
Hello, I'm trying to fix this error and what I've done so far I cleaned (no scratches) measuring scale and swapped cards (gantry 1 & 2) and cleaned scale reader sensor. There are no spare parts, I'm just trding to narrow down the cause. Any suggestio
Electronics Forum | Fri Feb 01 11:17:21 EST 2019 | youngbuck
Hi, Make sure to check any cracked, pinched, kinked hoses. Also when taking the whole gantry off there are clear hoses that can get pinched. Also, may want to changed the vaccum measuring board. Is this a S20 or F4,f5 or hs50 Thanks,
Electronics Forum | Fri Feb 01 07:21:32 EST 2019 | dfl
One of my 8mm feeders is blinking the red led after the pick-up. With both buttons the motor works as expected (forward/backward), but after the nozzle pick-up the motor moves forward and then the red led blinks. pressing the buttons the green led l
Electronics Forum | Thu Feb 07 12:50:21 EST 2019 | gregcr
Hi All, What are you running for selective solder flux? I'd like any opinion on water soluble and/or no-clean fluxes you are using. In our Kiss 104 machine we use HYDRO-X20 water soluble flux, per the original install suggestion, but I'd like to k
Electronics Forum | Mon Feb 11 19:29:04 EST 2019 | reckless
I am getting a CUI error on a DEK Infinity printer. The problem just started randomly after machine was all setup. We don't have any backup restore points so we are unable to re-install the software. Machine is running Windows NT. Can somebody
Electronics Forum | Tue Feb 12 14:13:56 EST 2019 | aldrich17
We executed that in IO screen all heads went down, N2323 sensor remained 0. And we cannot find N2223 sensor in the I/O screen. So now we are unsure of the issue but we are searching our manual in the "Placement Head" section hoping to come out with a
