Electronics Forum | Mon Oct 04 21:37:31 EDT 1999 | park kyung sam
| Hi everyone, I need some help on the whole process of double sided surface mount. We have been doing surface mount for about 3 months and we're getting ready to take on our first doule sided board. I just need some step by step process regarding so
Electronics Forum | Tue Oct 05 03:49:04 EDT 1999 | Chris May
| Hi everyone, I need some help on the whole process of double sided surface mount. We have been doing surface mount for about 3 months and we're getting ready to take on our first doule sided board. I just need some step by step process regarding so
Electronics Forum | Fri Sep 24 09:48:28 EDT 1999 | Shane
I am developing a DOE for evaluating SMT adhesives. I would like to evaluate 3 different vendor dispensing adhesives. I currently have the Heraeus PD955M and the Loctite 3609 and 3618 selected for evaluation. I would like to add another manufactur
Electronics Forum | Thu Sep 02 10:35:46 EDT 1999 | Gian.D
We are assembling double side pcs reflowing (smt) on top and by wave on bottom. After first step (smt) we dispense glue on the bottom side putting one or two glue dots under small components and we cure in oven before wave. After wave soldering we f
Electronics Forum | Wed Aug 18 08:38:46 EDT 1999 | Jason Gregory
| Is there process by which one can do a double sided reflow (SMT on both sides) in one pass through the oven? | Paul, Here's a way it might be done. Screen your bottom side with paste (if only passives, 0603-1206 & sot 23's), dispense glue for sam
Electronics Forum | Wed Jul 14 19:15:59 EDT 1999 | JohnW
| Can plcc's be glue on the a board if not why? | Ron, The biggest problem you have with PLCC's is the hieght of the base of the component from the board, if you can get a glue dot high enough then yes you could do it. Probably the best method is d
Electronics Forum | Fri Jun 25 12:07:00 EDT 1999 | John Thorup
| | hello, | | | | has anyone tried dispensing solder paste in thru holes instead of waving or hand soldering. if so how did it work out for you. | | thanks for the input | | | | wayne | | | | | | | We have tried this mainly on thru hole connect
Electronics Forum | Tue Jun 15 14:45:11 EDT 1999 | C. Cross
| I am looking for more information about: | | 1) What kind of evaluation can I do to measure the resistance to fall off of a bottom side glueded SMT component?; | | 2) There is some influence of doble wave solder machine (temperature, flux, etc) i
Electronics Forum | Fri May 28 12:51:11 EDT 1999 | John Thorup
| Does anyone have a suggestion for a UV resistant black potting material? The material recommended by a local vendor turned gray in a couple of months in the sun here in Florida. We are using L.E.D.'s in a small housing (about 1.2" cube) and need to
Electronics Forum | Mon May 24 13:06:12 EDT 1999 | Deon Nungaray
| | | Any suggestions on how to maintain Adhesive dispensing nozzles??? They seem to plug up over night and it is starting to get on my nerves. We have tried leaving the nozzles in the machine, removing them and soaking in alcohol, blowing them o