Electronics Forum | Tue Aug 21 19:24:15 EDT 2012 | rway
Checksum will work if all your doing is analog/passive testing. Checksum systems do not have digital test capability. I would recommend a Teradyne z18xx system. We use 8 of them in our plant and have been for years. Used, these systems range from
Electronics Forum | Tue Sep 18 10:52:14 EDT 2012 | sarason
Sounds like a plan. The usual way is to count how many you use on the job either by pre-calculation. Or how many clicks the machine counts and save the data before switch off, then drop it back into a spread sheet. This depends very much on the mach
Electronics Forum | Thu Aug 30 20:35:51 EDT 2012 | davef
A common bottomside heater configuration is IR-Convection-Convection. One of the big advantages of the IR zone is its ability to allow the flux carrier to spread and dry slowly before the board reaches the convections zones, which can blow wet flux c
Electronics Forum | Fri Nov 23 06:34:43 EST 2012 | bandjwet
With all of the various techniques available for LGA rework including but not limited to: Bumping the part using a polyimide stencil http://www.solder.net/products/stencilmate Bumping the part using a metal fixture or http://www.finetech.de/advance
Electronics Forum | Wed Feb 20 10:12:27 EST 2013 | dontfeedphils
Hey Bill, it really depends on the material you're looking at using UR, SR, AR, the easiest to deal with being AR, although if you can find a UR that doesn't clog up the machine too bad those are usually more viscous and easier to apply selectively u
Electronics Forum | Thu Feb 21 10:11:36 EST 2013 | patrickbruneel
The backflow in the wave started to become very important with the development of no-clean/no residue fluxes. These fluxes don’t have (or at least shouldn’t have) rosin, resin or other vehicles in the formulation which encapsulate surface oxides from
Electronics Forum | Sat Jun 08 13:16:06 EDT 2013 | unisoft
Take a look at the Unisoft software ( http://www.unisoft-cim.com ). For over 25 years this software has in use by Electronics Manufacturer CEM/EMS's and OEM's to automate New Product Introduction (NPI). It's perfect for Electronic Contract Manufact
Electronics Forum | Wed Aug 14 10:44:04 EDT 2013 | sarason
In my limited experience. A Domestic Dishwasher with no water recycling like which is offered on some of the newer high priced models works a treat. Clearly this is batch. Inline filtering of the water supply is a good ideal. There are several ways o
Electronics Forum | Thu Aug 08 16:18:22 EDT 2013 | horchak
Placing and re-flowing the shield is of course the most economical. But once the shield is placed and reflowed this all but rules out inspection test and rework. Reflow should not be an issue if you have a decent forced air convection oven. You may w
Electronics Forum | Fri Aug 30 21:54:14 EDT 2013 | nophsem
Well, the error occurs with Mod Code 56 (dispenser enable). Head # 1 has installed this accessory, but we use it very little and it wasn't this time. I probed setting 0,1,2 and 3. I downloaded Mod Codes from controller to assembler, then the error b