Electronics Forum | Fri Jul 10 15:28:47 EDT 2015 | sumote
I could really use some help, My oven is continually blowing one of the SFC fuses (the one on the left as it sets in the machine) when the conveyor tries to run. It appears that the traces on the circuit card were having too much current pulled th
Electronics Forum | Sat Jul 25 18:35:33 EDT 2015 | orbitcoms
I am looking for information regarding setting up an SMT assembly line. I have recently purchased a stencil paste printer, pick and place, and reflow oven. The main information I need is the paste selection and best finish material on the PCBs. I wil
Electronics Forum | Fri Sep 11 12:08:10 EDT 2015 | derrikf
I built one using an old Asymtek Automove. When all was said and done, it cost less than $400, including what was paid for the machine itself. It's a very basic setup, (air over syringe), but for our needs it does everything and more. With air to syr
Electronics Forum | Fri Aug 21 06:09:09 EDT 2015 | buckcho
Hello. Several companies offer what you seek, with different options (like reel traceability, msl levels etc.) depending what you need and of course how much are you willing to pay. I worked with 2 systems - Itac (which we bought) and one custom made
Electronics Forum | Tue Sep 15 14:11:59 EDT 2015 | jpal
You should also remove all the pump parts and clean them, checking the bearings and seals. Clean completely the parts that allow the solder to flow back into the pot; ours have a spiral that fills with dross. Treat yourself to new nozzles. Tinning
Electronics Forum | Fri Sep 18 13:11:38 EDT 2015 | dyoungquist
We used to run a TP9-2 but upgraded to the MY series about 5 years ago..... Encoder going bad is a likely possibility, especially on a machine that old. I can't say for sure that is your problem but we did have to replace an encoder on our TP9 (I
Electronics Forum | Sat Sep 26 02:09:39 EDT 2015 | aemery
Proc My field service back ground included Electrovert so I know reflow electrical quite well. I've worked on Heller, Conceptronic and Vitronics over the last few years and really there isn't a huge difference if you can read a schematic. I checked
Electronics Forum | Wed Dec 09 11:24:45 EST 2015 | ttheis
Thank you, Tushar, for the information and for the phone call; it is very kind of you to share your knowledge. I appreciate the advice to back up our machine configuration, mapping and calibration files. I installed the card in slot 2 per your docu
Electronics Forum | Fri Dec 11 16:32:26 EST 2015 | dilogic
I've bought used GSM's and registered them by UIC. As a result, I am able to access their web-based document archive, which is of great help if you need to repair something. From the software side, you're on your own. Try to find an old HD backup sof
Electronics Forum | Sat Dec 12 08:34:59 EST 2015 | jfeustel
Tom, we are in the Chicago area and we deal extensively with used Universal Instruments equipment. I probably have just about anything you might need for an older GSM in stock. I agree with Deni in that I would match a replacement hard drive very cl