Electronics Forum | Wed Aug 26 06:07:08 EDT 2020 | relaycz
Hi, We are planning to replace our ancient 3rd line with new machines. We've only ever had Samsung/Hanhwa PnP machines so far and I'd like to know about porting data between them and other manufacturers. Is it as simple as generating .ssa file and i
Electronics Forum | Mon Sep 14 22:59:42 EDT 2020 | kylet
Looking to power up this board with 3v coin battery. I've tested this board with it and it works but to solder this on or make something that has clips for the attachment to power this up. Positive and negative connections are the circles on the inne
Electronics Forum | Tue Sep 22 14:02:21 EDT 2020 | makersan
http://www.ltc.de/variogrid.html https://www.quik-tool.com/product.htm (they already said) http://www.crostu.com/products/rubber-supporter.html I haven't bought and used it yet. Would you share your experiences if you use any of them.
Electronics Forum | Mon Oct 05 17:07:31 EDT 2020 | dekhead
Older machine models (Horizon / Infinity) allowed you to offset the board stop (thru crative programming) to run the larger board with parameters for the smaller board. That feature is eliminated with the Micron series. However, if you can get remote
Electronics Forum | Tue Oct 06 11:21:26 EDT 2020 | dontfeedphils
I'm not sure if any of the docs I have contain the info you're looking for, but here's what I've got. https://drive.google.com/drive/folders/1ZD2gMsvIu8QB9Ikj5LZivoO2RpwlYEN-?usp=sharing
Electronics Forum | Thu Oct 08 16:42:05 EDT 2020 | babe7362000
Does anyone have Page 6 and 7 of the MPM SPM manual? I am currently having issues with low air pressure that pushes the table in. I get good air that pushes the table to the entrance, but I do not get good air pressure that pushes the table in. I
Electronics Forum | Mon Oct 12 03:12:42 EDT 2020 | erici
TP11 is always showing the error that E-stop is not released. This happens when we start up the machine. It is basically hit and miss, sometimes will work but most of the time this error will pop up. Any suggestions on how to correct this. Is ther
Electronics Forum | Thu Oct 22 22:13:20 EDT 2020 | gabriel1blue
I got new belts for the original floppy drives and installed them but the machine was reset to Japanese and after changing it back to English the drives are not running or powering up even though we can measure that the 5 volts are coming into it. I
Electronics Forum | Tue Nov 03 19:26:31 EST 2020 | aurash
I have a KE2050RL which I just started (second hand) and the machine goes in operator mode by default. Any idea how to reset the password for Manager level ? can be reset from service level? is there a service default password? Thanks, Aurash
Electronics Forum | Fri Nov 13 19:37:31 EST 2020 | jmelson
Yup, that's the first thing I looked at, the pogo-pin block on the front, and where the motor plugs in. Both could be stress points. I will try resoldering those anyway, although they looked fine. I examined the rest of the board, too, and could n
