Electronics Forum | Wed May 22 19:10:47 EDT 2013 | anvil1021
We do a lot of these devices and I guess I am not familiar the term "Dry Solder". The QFN device is not designed to have a drain hole, but needs to have thermal vias to control heat in most cases. We have used every possible gnd pad design and modifi
Electronics Forum | Thu May 07 20:28:35 EDT 2009 | davef
From our notes, the following is a series of snips from: "Copper Dissolution in Tin" LJ Turbini, PhD, adjunct faculty member, University of Toronto, Materials Science and Engineering, SMT 2/07 As the solder becomes molten, copper from the board diff
Electronics Forum | Sun Aug 15 11:02:37 EDT 1999 | Jeff Ferry
| Ladies and Gentlemen, | | As a newly appointed DFM/CE "guru" here, one of my responsibilities has become repair (of course). As I have some knowledge of BGA repair/rework using semi-automated equipment, it naturally follows I would hav tremendous
Electronics Forum | Thu Oct 01 16:56:40 EDT 2009 | gplume
Does anyone out there have experience soldering with Pb solder (Sn 63 or Sn 62) to SAC 305 coated PCB lands (about 50um) or Sn-Cu plated lands (about 10um). I know soldering Pb free (Sac based soler) to Pb/Sn coated lands is a no-no, but was waonderi
Electronics Forum | Fri Oct 02 09:22:24 EDT 2015 | derrikf
The following is representative of on-board temps of a FR4 at .069" thickness. The thermal couples were soldered directly to the board using high-temp solder. Again, the halogen-free solder requires an identical profile to our old solder. We had grea
Electronics Forum | Mon Dec 21 09:58:34 EST 2015 | dyoungquist
We are using Metcal STTC-8xx series tips. One thing that makes a huge difference on tip life is what type of solder you are using. If you are soldering with lead (SnPb) solder the tips will last 3 times longer on average than if you are soldering w
Electronics Forum | Wed Aug 04 20:06:24 EDT 2004 | C.W
Customer returned a brd claim that one of the FPGA is having "cold solder joint". I inspected the the BGA location with X-ray and Ersascope, balls' shape look fine, voids are not detected, perimeter joints show shinny and smooth appearance, i have se
Electronics Forum | Thu Feb 17 11:38:53 EST 2000 | Steve Thomas
We appear to have solved a major reflow process problem (poor quality joints on a 20 mil QFP100...excessive solder left on the lead leg, not much left for a joint) with a design change to the board. We gave ourselves considerably more room for a hee
Electronics Forum | Thu Feb 17 11:38:53 EST 2000 | Steve Thomas
We appear to have solved a major reflow process problem (poor quality joints on a 20 mil QFP100...excessive solder left on the lead leg, not much left for a joint) with a design change to the board. We gave ourselves considerably more room for a hee
Electronics Forum | Wed Jun 17 16:00:47 EDT 1998 | Frank
| | Does any one wave solder the 0402 Chips on the bottom side of a board? | | Any comments? | You will need to use a curable epoxy at the site of placement before placing the 0402--then cure the epoxy...possible problems are epoxy intrusion on the