Electronics Forum | Thu Mar 01 06:12:18 EST 2018 | reckless
I am new to SMT and need to buy a pick n place machine that runs ~7500 cph and super reliable/no headache. My budget is $10,000. Either I buy seriously used (~15-20 years old gsm) or new Chinese unit. I saw this video and am seriously considering
Electronics Forum | Thu Mar 01 11:18:56 EST 2018 | reckless
EVTimov, Thanks for responding with your thoughts. I appreciate it! In regards to your thoughts, my biggest issue is we do use alot of 0402 components. This unit is probably built on their success of their simple table top unit which no one has
Electronics Forum | Fri Apr 06 02:17:15 EDT 2018 | rob
@ Sr.Tech, Most of our Chinese spares are Juki & Yamaha original & still bagged, just much cheaper. They wouldn't sell machines in China if all the spares and consumables were at European mark ups. Nozzle wise the Juki 750 & 760 copies are not 100%
Electronics Forum | Thu Mar 15 18:15:28 EDT 2018 | maustin
The 740 has been a great machine for us. We've been able to reliably load components as small as 0603 (we've not tried 0402, but I believe with a special nozzle adaptor, you can get it to work) and place a 7x7 56 pin QFN with 0.4mm pin pitch with hi
Electronics Forum | Tue Mar 20 05:29:30 EDT 2018 | rob
Fuji makes great machines, just depends on the local support If you are not doing anything special I'd probably just go with the I-pulses as you'll get a lot more machine for your money, and have some left over for inline AOI/SPI or look at somethin
Electronics Forum | Wed Mar 28 15:48:42 EDT 2018 | reckless
I have 3 phase power in my production area where I am running this machine. Technically the 110V was a wish as I have an empty office where I can put a number of machines but it doesn't seem like I would. So power is not an issue. I even have 480V
Electronics Forum | Tue Apr 24 09:19:51 EDT 2018 | vetteboy86
Is there a preferred method among printed circuit board assembly for accurately and quickly verifying the copper weight of a printed circuit board? I would like a tool and process that our quality inspector could quickly use to verify upon receipt of
Electronics Forum | Tue Apr 24 21:00:58 EDT 2018 | marlonbc
Hi All, Would just like to course through this concern on a product that we are contracted to assemble. It is mainly used for an automatic hand sanitizer dispensing product. By design there is a restrictive value of current that it needs to dissipat
Electronics Forum | Fri May 04 16:19:52 EDT 2018 | solderingpro
meaning its non-eutectic. You would want to stay as close to 350°C as possible or (if a slightly off version of SAC305) target the highest melting point of your chemistry) - assuming your temp controller is properly calibrated that is. Other option
Electronics Forum | Fri May 11 09:17:12 EDT 2018 | charliedci
I have used a 2006 Electrovert Vectra ES (63/37) for last 3 years, we acquired it used. It had little or no maintenance before we got it, now after replacing a solder pump motor, preheater fans and thermocouples it is pretty reliable. The spray fluxe
