Electronics Forum | Tue Feb 25 17:41:29 EST 2020 | emeto
What we did not talk about is Mycronic machine. Great choice for small batches.
Electronics Forum | Tue Feb 25 18:11:40 EST 2020 | kylehunter
> What we did not talk about is Mycronic machine. > Great choice for small batches. Yeah? That's what I keep hearing! Would use that exclusively for small runs, with the Opal for larger batches.
Electronics Forum | Thu Apr 30 02:09:50 EDT 2020 | bukas
Thank you for you reply yernie. This forum is about industrial electronics assembly machines and technologies and not about smartphones. btw, the problem was IF board if anyone was wondering.
Electronics Forum | Tue Feb 25 10:30:02 EST 2020 | richardcargill
If you get the stencil made with all apertures included then you can blank some off with sellotape. Saves you buying 2 stencils should you require them machine fitted in the future
Electronics Forum | Wed Feb 26 13:23:40 EST 2020 | rgduval
I haven't used these clips, or this machine, so... But..in general, I'd use as large a nozzle as you can that fits the pick area of the clip. That should give you the best opportunity at lifting the clip. If the machine has a gripper nozzle (with
Electronics Forum | Mon Mar 02 10:09:47 EST 2020 | abarrow
Update-Please disregard Hello, new to the forum and machine so please bear with me. I am looking to change the pitch index on 12 and 16mm cl feeders. Is there a setting that I am not seeing or is an intelligent feeder required for this. Thanks in adv
Electronics Forum | Mon Mar 02 16:58:41 EST 2020 | rlising
Has anyone on the forum own a EASTONTECH EW-02A wire stripper and cutting machine? I get a message after a cut. Output amounts vlue. Please recount.
Electronics Forum | Mon Mar 09 16:22:05 EDT 2020 | sportsradar
Hello Kristof, We use 1 PC which does line control and programming. We always boot the PC up first, then when it is fully booted, then we turn the machine on, we let it zero set, then we send the job over (this is how we do it when everything works)
Electronics Forum | Fri Mar 06 22:15:53 EST 2020 | portersmt
What other maintenance items/tasks do you guys perform on your machines on a regular basis? We fortunately gotten away with doing little to no maintenance on ours in the 5 years we've been using it.
Electronics Forum | Tue Mar 31 09:25:18 EDT 2020 | emeto
If you believe your picture is in the middle and is not skewed, than go to your basics and recheck your fiducial locations and detection. Sometimes these machines recognize something around and give you this error. Try program with isolated pads and
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477