Electronics Forum | Tue Aug 04 14:06:59 EDT 2020 | stephendo
Are you sure it is not a 240V transformer with a center tap? That is how residences are wired. If you use the center tap you get 120V. The other tap to center tap is 120V that is 180 degrees out of phase. So if you use the two outside taps you get 24
Electronics Forum | Tue Aug 04 14:28:39 EDT 2020 | ttheis
Yes, I am certain it is 240 corner grounded delta. It confuses many electricians and it took me some time to understand. It is fed from a 480:240 delta 200A transformer. As I mentioned, they have a lot of Bridgeport 3ph machines and cnc machines conn
Electronics Forum | Thu Jan 07 19:22:55 EST 2021 | dilogic
Thanks, I have read (almost) everything I could find on UIC's site. The problem I had was that I never before tried to perform FJ calibration, so I did not know how it normally works. Anyway, I figured out what I did wrong and managed to calibrate t
Electronics Forum | Wed Jan 20 16:26:34 EST 2021 | ttheis
Low Air Pressure: System reporting low air pressure; verified 12Vdc at pneumatic panel, manually jumpered and verified connections back to GPIO1 connector on the LOC I/O assembly. Swapped LOC IO cards then entire LOC IO chassis, with another machine.
Electronics Forum | Wed Feb 10 14:33:40 EST 2021 | lewis_and_clark
Hi Tom, Spoke with our technical team and our feeder division tells me that the GSM Pneumatic feeders are not compatible with the Advantis Machines, however the Multi Pitch 24 Volt Feeders are. We have a large customer base that uses the Advantis m
Electronics Forum | Tue Mar 02 12:29:52 EST 2021 | astarotf
Hi Travis H, Thank you very much for answering and helping. Apparently, but I'm not sure what the X linear bearing assembly is. The replacement part I am looking for is I believe this it
Electronics Forum | Tue Mar 02 16:05:46 EST 2021 | travishemen
The document I am using is through Universals Voyager software. It contains all the manuals, part lists, procedures, etc. It is an installed piece of software so it would be hard to share. I was able to find the pdf of this breakdown. I assume th
Electronics Forum | Wed Mar 03 10:14:45 EST 2021 | spoiltforchoice
I don't have one of these machines, but what kind of checks are you able to do on the linear encoders? On our Essemtec there is a dedicated diagnostic utility that gives you a plot of the encoder readout showing both the raw readout as a sort of roun
Electronics Forum | Wed Apr 28 15:18:17 EDT 2021 | dilogic
24V feeders are very simple to interface. You have supply voltages (24VAC, 12VDC), status output and control input (advance). All signals are using 12V levels. To advance feeder pull control input to GND. Connect status output to +12V with a pull-up
Electronics Forum | Mon Sep 20 22:17:04 EDT 2021 | ttheis
SOLVED Upon manually activating the zaxis to drive the spindles down, it was noted that the touch down sensor for spindle #2 was activating at a certain point in the travel without touching anything. I went to look at the adjustment of the sensor