Electronics Forum | Tue Dec 18 03:29:01 EST 2018 | alicecai
Hi Tom. I think you can try our website and quote online. Here is the link:https://www.k-pcba.com/. Thanks in advanced!
Electronics Forum | Wed Apr 25 05:57:28 EDT 2018 | marlonbc
Hi, I am looking for service providers who can help me with determining the age in actual use of an assembled product (PCBA + plastic assembly) if the PCBA is not conformally coated. The actual use will be on car dashboards much like an action came
Electronics Forum | Thu May 03 09:58:05 EDT 2018 | jimpat
Can anyone advise on the approximate cost of a reflow oven with vacuum? Just looking for a ballpark number to see if it feasible for us.
Electronics Forum | Thu May 03 15:02:59 EDT 2018 | solderingpro
Bob Willis (was the first I knew of) that has a splatter test that can be performed over a ceramic hot plate or the like. The concept is pretty straight forward, using a zoned circle, users can introduce the solder wire at a consistent rate and coun
Electronics Forum | Mon May 13 13:20:20 EDT 2019 | carlosbarron
Hi Dex, This is Carlos and I am having trouble for the camera show visual on screen. To haven't been able to troubleshoot because the machine doesn't have schematics or manual of any kind. Can you help on sending copies, please. Thank you, Carlos
Electronics Forum | Tue May 14 04:01:35 EDT 2019 | oxygensmd
Can I ask the docs too? Do you have docs for Accela? Please send them via PM. Thank you very much!
Electronics Forum | Wed May 09 10:56:52 EDT 2018 | rickeydad
I would like to know the hardness figures of ENIG finish and hard gold finish. I can find the hard gold finish number and it appears to be 130-200 knoop. But what about ENIG finish?
Electronics Forum | Thu May 24 09:01:01 EDT 2018 | mattkehoe
OK, one more question about our MPM. When we flip the table lock switch it does not seem to lock very tight. XY adjustments can still be made even with the lock on? Suggestions??
Electronics Forum | Thu May 17 06:46:39 EDT 2018 | godless
After fresh install and loading only machinekey + stdeaf files it worked, thanks. But still there is camera problem which appeared from the beginning. I attached files where you can see error details. Software reinstallation not solved issue. Then ca
Electronics Forum | Tue May 22 09:19:10 EDT 2018 | cyber_wolf
This is caused by usage. Excessive squeegee pressure can make it worse over time.It will become more pronounced on thinner stencils. Unless it is causing printing defects, don't worry about it in my opinion.
