Electronics Forum | Fri Sep 13 14:33:32 EDT 2002 | Simon
Thanks to all of you. This is very kind. I'll have a good poke around the circuit board for loose / hot components - good tips. I think it might be a throw away job, but I thought I'd give it a last try. You guys have actually given me much more
Electronics Forum | Tue Sep 24 14:29:32 EDT 2002 | stepheno
We have a board with 16 SMT connectors, side by side. We get some unsoldered pins on the connectors. There is about a half inch gap between them. The enigeer in charge of the project said it would cost too much to make something and didn't think it
Electronics Forum | Thu Sep 19 17:14:02 EDT 2002 | davef
Comments are: * Use an eraser if the surface of Au is not clean, but make sure the eraser has no/low ionics (such as sulfur that is a common additive for rubber). * If the plating surface required eraser to remove the top surface, the plasma normally
Electronics Forum | Mon Sep 23 16:13:42 EDT 2002 | robf
Isn't this a blatant violation of rules? Couldn't Bill have e-mailed a response directly to the poster? I'm not sure if acts like this frustrate users that actually are the people who work in this industry but it definately frustrates suppliers who
Electronics Forum | Mon Sep 30 20:41:25 EDT 2002 | jason
Hi, The acceptance level for voids is 25% and most of it on your case should be the paste. If you want to reduce / eliminate it, you gotta have the Production to practise FIFO for the usage of the paste. If it is expired paste or exposed to long
Electronics Forum | Mon Oct 14 08:29:37 EDT 2002 | cyber_wolf
I don't think that anyone is saying we want to barr reps at all. I think the issue is that people get irritated when when certain reps work their sales shpeels into a forum response that does not warrant it.That's all. I value this site tremendously
Electronics Forum | Mon Oct 14 18:30:49 EDT 2002 | seand
Hello all, My tankard is hoisted on high. I always feel that it's good to get a good discussion going with alot of input. My thanks go out to all who have and continue to respond. Sometimes the best outcomes come from the most hotly debated topi
Electronics Forum | Tue Oct 15 09:04:06 EDT 2002 | sueph
Dear Pete, thanks for the reply. My calibration procedure says pretty much what you said: variance of 10 degrees F. I am having a temp. swing of close to 80 degrees F. and no matter how I try to situate the thermocouple back into the preheater, I ca
Electronics Forum | Mon Oct 21 18:31:45 EDT 2002 | MikeF
Mike, If your wave solder machine doesn't have enough preheat capacity you can put the board in an oven and warm it part way before you put it into the wave solder machine. This works best with a spray fluxer, as a warm board will collapse the foam
Electronics Forum | Mon Oct 21 09:58:28 EDT 2002 | cnoonan
We hare having an issue with our chip shooters misplacing or not placing parts all together. We have traced it back to our adhesive machine. We are using both single and double dot nozzles. I feel that the biggest problem is excessive amounts of g