Electronics Forum | Wed Aug 13 21:03:01 EDT 2003 | davef
Your dust collection / humidity / ionic path concern is reasonable. Consider applying your conformal material thick enough to form a good barrier between the device edge and the board, similar to what you do for QFP. [Admittedly the QFP is not a pre
Electronics Forum | Sat Jul 22 03:27:36 EDT 2023 | shrikant_borkar
hi here are consolidated inputs to you you must validate before establishing your process. ESD-safe Material: Ensure that the masking tape is made of ESD-safe materials that have low triboelectric charge generation. Common materials used in ESD-sa
Electronics Forum | Tue Jul 28 17:35:07 EDT 1998 | Brian Stumm
Steve, I know it is tempting to go for the cheapest method of applying conformal coatings but I must warn you. If you are a contract manufacturer then you don't want to limit yourself in the types of coatings you can work with. Just as soon as you se
Electronics Forum | Tue Jul 28 17:44:03 EDT 1998 | Brian Stumm
| Steve, | I know it is tempting to go for the cheapest method of applying conformal coatings but I must warn you. If you are a contract manufacturer then you don't want to limit yourself in the types of coatings you can work with. Just as soon as yo
Electronics Forum | Tue Nov 01 10:06:00 EDT 2011 | davef
Humiseal says: Typically, there are three main approaches to avoid coating wicking into press-fit connectors (and other keep out areas). Wicking is a phenomenon caused by a combination of low viscosity of conformal coating material and strong capilla
Electronics Forum | Thu Jun 01 21:54:00 EDT 2000 | Dave F
Jeremy: Standards: � A-600 talks about percentage of solder mask loss allowed, according to the location (eg, laminate, bare copper, gold or nickel, melting metals) and equipment class. � A-610 talks to "Solder Resist Coating - Voids & Blisters" by
Electronics Forum | Wed Nov 11 08:37:46 EST 1998 | Wayne Bracy
| I have a need to dispense a latex masking material using an automated dispensing system. We are presently looking at the I&J750. Does anyone have any experience with this piece of equipment, or have a better solution available? | Doug: You mig
Electronics Forum | Fri Mar 06 19:19:54 EST 1998 | Pat
Just recently tryed Miller Stephenson MS-465 spray, worked well. Also using Loctite 5290. The MS-465 air dried in about 15 min. The loctite requires ultra violet curing which took about 50 seconds, but didn't cure completely. The loctite will also
Electronics Forum | Tue May 14 20:43:55 EDT 2002 | davef
I feel as though I�ve just walked in to a bar, where everyone I was supposed to meet has been drinking for 3 hours. First, the volume of water displacement thing doesn�t make sense, as others have commented. Second, I believe Dave Robbie wants meas
Electronics Forum | Thu May 01 13:58:14 EDT 2003 | bremerg
Gentlemen, Does anyone have any failure information on IRC, CHP2-100-R500F (5 OHM, 2W, 1%) resistors. We have experienced two failures on the same circuit board where the metalization on the component separated from the component causing an open ci
.gif)
