Electronics Forum | Tue Mar 09 22:47:26 EST 2004 | pdeuel
Contact sensors out of adjustment. If you push up on spindle the led should change state. same if spindle is pulled down. I have also had problems with PTIF error during zeroing Soft stop. last messages recieved were reported as z axis time out durin
Electronics Forum | Wed Mar 24 21:11:05 EST 2004 | longpham246
Contact Lean Stream in San Jose California, ask for Bob Jones at 408-605-0141 for best solution. He has new feeder at extremely low cost that work out best for me. Long Pham
Electronics Forum | Thu Mar 18 07:35:06 EST 2004 | Alan
Thanks, I have more than enough resources now. I am especially interested in the Nix Carrier Tape Tray. Such a simple idea. Thanks for the contact info. Frank.
Electronics Forum | Sun Apr 04 13:37:53 EDT 2004 | metats
Thanks for everything, it ended up being worn out brushs in the cut and clich motors. A little clean up and some elbow grease and its all ok. Thanks again, Paul
Electronics Forum | Fri Mar 12 15:57:30 EST 2004 | jseagle
Check the cables first, they get damaged after a while by the turntable for the monitor, lots of bending. We had to replace our cables. Also, have you checked the monitor? We had to replace ours. Our 3AV is 8 years old. James
Electronics Forum | Thu Mar 18 14:24:15 EST 2004 | pjc
Try contacting the vapor desgreaser mfrs.: http://www.trekindustries.com/index.html http://www.ultronix.com/ http://www.thermalequipment.com/Evalservice.htm
Electronics Forum | Fri Mar 12 11:41:53 EST 2004 | pjc
Don't detach the bead and don't twist the wires! The bead should be what makes contact with where you want to measure temperature. Tape is not the ideal method to attached thermocouples for reflow soldering but is OK when using for wave solder prehea
Electronics Forum | Fri Mar 12 11:41:54 EST 2004 | Claude_Couture
The solder bead IS the thermocouple. A thermocouple is two different metal welded together. The junction generates voltage. You can use tape, glue, paper clip, whatever works on your particular situation. Just make sure the thermocouple does not move
Electronics Forum | Sat Apr 03 05:21:33 EST 2004 | mattkehoe
There is a method for VIP you may not be familiar with. I dont want to go into depth here but check out http://www.sipad.com/sipadvip.htm and contact me off line if you want more info. Good luck. mk
Electronics Forum | Mon Mar 29 12:29:05 EST 2004 | Donn Bellmore
Placement pressure can be checked by using load cells. Both PCP and Entran make them and the amplifiers. They can be contacted at the following websites. PCP http://www.pcp.com Entran http://www.entran.com