Electronics Forum | Fri Mar 22 21:31:25 EST 2002 | ianchan
Hi Guys, Anyone have "comments/testimony" on having possible quality level achievements, for AQL=0.1, C=0 ??? Is this a realistic "1st Pass Yield" expectation? how about for OQC submission Lots from production? especially in a high-mix, low-volu
Electronics Forum | Tue May 21 14:12:19 EDT 2002 | dougt
I'm starting to see faducials used more and more on pick and place equipment and this sounds like a good place to use them. Does anyone out there have feeders with faducials on them yet? I'm told that a couple machines are running these to place 04
Electronics Forum | Tue Aug 06 08:55:07 EDT 2002 | Brandon
How do you calculate downtime of an SMT Line with 5 machines (1 Printer, 3 Pick and Place and 1 Oven)? Let's say that my stencil printer is down, since it is the beginning of my process my whole line is down. But if my 1st pick and place machine is
Electronics Forum | Mon Nov 25 20:38:39 EST 2002 | davef
That's basically it. In a wonderful world, the oxides flow on top of the flux during heating through reflow. Obviously when compared to reflow soldering, you create much more dross with your wave by: * Pumping a large volume of very hot solder to h
Electronics Forum | Tue Dec 23 11:06:00 EST 2003 | ex maintain leader
I'm agree with suggestion "ceaning importance" you schould make your leader job in three group of maintenace the equipment 1st daily maintenance line operator is responsieble to lean the machine on the surface where is not need any tools required
Electronics Forum | Mon Jan 26 07:27:43 EST 2004 | loz
I have a product that has earthing/positioning holes, as they are to be used for earthing purposes they need to be free from conformal coating. This pcb is double sided. I have used spot/peelable mask to protect these holes. However when the conforma
Electronics Forum | Mon Mar 01 21:52:56 EST 2004 | Ken
Asking the Grid Lok to flatten out the board is like asking the SMT Reflow Furnace to detab the panel. It was not designed to make up for the deficiencies of your fab supplier or your unsuported 1st reflow pass on the the chain conveyor. However, i
Electronics Forum | Tue Mar 01 10:31:26 EST 2005 | Greg
QC --> Touch-up --> QC --> Assembly After SMT all PWB goes to QC, QC Inspects and marks all that needs rework then PWB's goes to Touch-up to fix what QC marked for rework. After that All reworked boards goes to QC for another verification and stampi
Electronics Forum | Tue Mar 01 10:50:32 EST 2005 | pr
I think the 1st option would be the best. I have found that a touch up person WILL TOUCH UP SOMETHING, regardless of the electrical needs of the board. This leads to a lot of unnecessary rework of joints. I would hope QC is tracking the defects and t
Electronics Forum | Sun Mar 06 17:39:15 EST 2005 | Darby
1st law of Surface Mount. You WILL run out of parts on the last board going through before a long weekend. 2nd law of Surface Mount. Touchies WILL touch. I'm with Russ and Rob. Touch up is EVIL and should only be tolerated in exceptional circumst
A dealer of high quality Used SMT Equipment, Used Plastic Injection Molding Equipment, Used Machine Tools, Used Semiconductor Machinery, and Used Industrial Machinery.
Equipment Dealer / Broker / Auctions
104 East Street
Middleton, MA USA
Phone: 978 790-2774
