Electronics Forum | Thu Jul 28 07:23:24 EDT 2011 | scottp
My group supports a couple hundred lines all over the world. Most of them use squeegees but a few use either the MPM Rheometric pump heads or the DEK Proflow heads. I absolutely hate the enclosed heads. Flux separation, compaction, and the print q
Electronics Forum | Thu Apr 05 13:54:18 EDT 2001 | CAL
Do the parts sit directly on the PCB? Typical 2.0 mm Max is desired for the component to be off the PCB. Are stand-offs an option? The long lead wiggles as it passes through the wave and thus agitating the air out.Does your wave a "dancer" option?
Electronics Forum | Wed Aug 06 14:49:06 EDT 2014 | dyoungquist
Sn62Pb36Ag2 has a higher liquidus point of 189C as compared to Sn63Pb37 at 183C. You may need to slightly adjust your oven profiles to use it compared to SnPb. We have had good solder-ability and reliability with it in our IPC Class II products. A
Electronics Forum | Thu Dec 10 12:53:12 EST 2009 | deanm
Bryan, Dyoungquist is correct. You should not need to mix solder paste. Overmixing solder paste can adversely affect it. Follow these guidelines and you should be fine: 1. Keep unopened containers of paste in the refrigerator. 2. Take one container
Electronics Forum | Tue May 09 09:07:46 EDT 2006 | eyryren
C/O general manager Dear Sir This is Shenzhen comofaje Tech.co.,Ltd from China mainland We are the Associator of Hi-tech industry Association, so I think we can become your supplier in China. Now we have Four series products:1 SMT stencil wiping ro
Electronics Forum | Mon Jan 09 23:24:47 EST 2017 | saju86ece
Hi, We are doing pin in paste reflow process in one our product ( but paste printed on bottom side of the board and top side will be assembled through hole component)in which faced cold solder issue in THT capacitor location after reflow. The solder
Electronics Forum | Mon Jul 16 21:25:26 EDT 2001 | davef
Sure, use of U-shape apertures is another way to reduce the amount of paste that you apply. That and similar schemes mentioned in the article are not a function of the flux used. We have used U-shaped apertures for MELF and mini-MELF. They are sug
Electronics Forum | Tue Dec 30 09:31:52 EST 2014 | rgduval
I've always approached it like this: Design your processes and perform your work to class three standards, and inspect to the standard that is acceptable. That is, all work should be performed to the highest degree of quality. When the work is ins
Electronics Forum | Sat Jan 10 09:04:47 EST 2015 | jandon
class 3 requires 100% barrel fill Class 3 requires 75% vertical fill of solder for component with less or more than 14 leads. Not 100% fill.
Electronics Forum | Tue Jan 05 18:07:53 EST 1999 | Dave F
| I am looking for information regarding post wave soldering of stranded wires into a circuit board using OA core wire solder. We do a final pass thru the cleaner after the hand soldering but I'm concerned about any OA flux residue that may have wic
.gif)
winsouce.jpg)
