Electronics Forum | Sun Apr 23 09:04:36 EDT 2006 | kanna
Does anyone have any experience with these ovens > ? We are looking at purchasing a used > one. Anything in particular I should look at > when inspecting it ? > > Any comments good or bad > appreciated..... > > Thnx, Sr. i have one problem he
Electronics Forum | Thu Apr 23 12:22:35 EDT 2015 | ercdave1
Thank you for looking at my post. my problem is this. I have a Conceptronic Mark 111 Reflow oven that randomly turns off zone 4 and stops the conveyor belt. turning the heater and the conveyor off on the software and restarting them gets things ba
Electronics Forum | Thu Jul 15 10:33:59 EDT 1999 | Michael Zadrejko
| | I am trying to solder a 388 ball BGA to an Andon Electronics Corp. BGA socket adapter and I am having problems in the reflow of this part. I put no clean paste flux in the solder cups of the adapter then put the BGA part onto the adapter and run
Electronics Forum | Mon Oct 08 18:21:27 EDT 2007 | mariss
We have recently acquired a Passaat SMRO-0406 oven. The manual is uninformative for oven settings. Can someone supply us with starting points for conveyor speed, Zone 1 to 4 and 5 to 8 temperature settings please? Our boards for a product we manufac
Electronics Forum | Tue May 07 09:26:38 EDT 2013 | emeto
Hello knowledgeable people, we have Omniflow 10Zone oven from 3-4 years and we changed over 20 blowers. The blower is German and I think is a very good quality(quite expensive too), but still keep getting bad. Does anyone have similar problem? Do yo
Electronics Forum | Thu Nov 18 00:28:02 EST 1999 | Scott McKee
Use Mydata. I've built huge backplane boards, round boards, 1/4" thick boards, 1"X24" boards, 1"X1" boards, L-shapes boards; all without any carriers or tooling. If you buy a MY15 you can increase the board size to 5'X2' (60"X24")... As for ovens,
Electronics Forum | Wed Apr 16 14:50:48 EDT 2003 | jonfox
sounds like a profile for some type of adhesive. depending on your required profile (manufacturer supplied) make sure that it matches it. For most adhesives (loctite, etc...) you just have to make sure it reaches a certain temp (150C for example
Electronics Forum | Sun May 20 23:15:34 EDT 2007 | dsd
George, The Radiator is only used on the older Nitrogen ready type Heller Ovens to attract the flux toward the Flux Filtration system. There should be two blowers in the Cooling zone where the radiator is to be fitted and there should be 4" ducting
Electronics Forum | Wed Sep 03 07:39:19 EDT 2008 | pjc
You may not be getting enough exhaust pull, so the cooling modules over temp. Try swapping blower motors to isolate that before buying one. STANDARD AIR OPERATION: - Load-end: 150 cfm (255 m3/hr) at the 4� (102 mm) stack (minimum requirement) - Unlo
Electronics Forum | Sat Jan 05 00:13:16 EST 2002 | Chris Veeneman
I have experienced the same problem with my Mark 3. I found the problem to be the solid state relays in the electrical control panel. Towards the front of the machine below the breaker rails. My oven's computer screen would show all was fine but my
