Electronics Forum | Thu Dec 24 14:52:24 EST 2020 | bobpan
Good job, For the comm errors i would try: 1. Reseat all the cables that plug into the white multiplexer that is attached to the back of the computer. 2. Reseat the EPCU card down inside the machine. good luck, Merry Xmas, Bob
Electronics Forum | Wed Dec 23 20:06:26 EST 2020 | marcelorotofrance
Hi, I'm using a "ye olde" Quad 4c Mk2 built in 1995 for eight years. During that period I had to change 3 HDD (now it runs a compact flash with and free DOS), 3 Z-rod bellows,3 laser heads, some monitors, nozzles and misc parts. Despite that it has t
Electronics Forum | Wed Sep 04 12:50:40 EDT 2019 | smrsteve
Thanks for that Steve - I'll try anything at the moment, but that sounds like a reasonable suggestion. I've already replaced a few cables that looked dodgy, and the LEDs on the LED rings, but I've not done a ribbon cable on the head yet. I shall hav
Electronics Forum | Wed Sep 04 13:40:46 EDT 2019 | smrsteve
Hello DWL, Thanks for the response. I've measured the components with a micrometer and set the sizes. Maximum tolerance on my machine is 20%, and that's what I'm using. If I do a manual scan, the measurements are exactly right (and what I've set up
Electronics Forum | Wed Sep 04 14:12:26 EDT 2019 | bobpan
It sounds like the vac-verify is not working. There is a command on the hht to turn it off. When turning off your hht will show either 'idle' or enter command' without the V showing anymore. Maybe try the cntrl and vacuum or shift and vacuum. If its
Electronics Forum | Thu Sep 05 08:33:54 EDT 2019 | bobpan
Make sure your placement rotation co-ordinates are correct. If you do a function 3 it will show you. I think they should be in multiples of 6000....ex...6000 = 90 deg. Also check the z axis number. I dont think its cyber or vac related. It is somet
Electronics Forum | Wed Dec 23 22:34:22 EST 2020 | bobpan
Hello Marcelo, When you initialize the system in central controller...does it see mvs? Will a different job that you ran before work or does the same error happen? When do you see this error. You can email me at http://www.precision-repairs.com if y
Electronics Forum | Wed Sep 04 12:01:59 EDT 2019 | slthomas
My recollection of the 4c is fuzzy but I know that there's a ribbon cable on the head that gets some abuse when the head rotates. Seems like mine would eventually break at the crimps and I had to replace it a few times. Eventually I bought the parts
Electronics Forum | Tue Oct 10 12:32:08 EDT 2006 | RLM
Larry, I have had this problem in the past. It turns out that there wasn't enough "Z" on our nozzle pickup locations. When a nozzle change occured the nozzle would not be fully seated on the Z-rod. When the Z-rod is driven down to pick the first part
Electronics Forum | Thu Dec 24 12:43:18 EST 2020 | marcelorotofrance
Hi Bob. When I initialize the system, all functions appears. In "Utilities/Initialize System Comm" option too. I have to confirm yet, but this problem appears to not happen in all programs. The red error message shows when I launch the program. My su
