Electronics Forum | Wed Feb 20 18:04:56 EST 2013 | hegemon
You should have a number of lighting options to deal with the low contrast lettering. Low angle, B/W, reverse color. etc... If I am reading you right, you might have your bridge inspector too far out on the lead banks, that it is seeing the silkscree
Electronics Forum | Fri Mar 15 15:34:37 EDT 2013 | anvil1021
In my experience used reflow ovens have been problematic. There are lots of adequate or better reflow systems out there that wont break the bank too badly....the N2 question, if you are going to be using solder that requires higher reflow temp than d
Electronics Forum | Mon Oct 07 22:06:43 EDT 2013 | action_101
I successfully inspect solder on plcc's with angled cameras on the yestech we have. In the past I have successfully inspected for solder with angled cameras on mirtec machines for both plcc's and qfn's. Other than inspecting solder on those two types
Electronics Forum | Tue May 21 15:30:21 EDT 2013 | williamaxler
There is two different ways to make this work. To get the Add Project button enabled find your EasyOLP installation folder and modify OLPoptions.ini change MultiProject to 1. Now you will be able to add multiple jobs together and optimize. You c
Electronics Forum | Fri Jun 06 02:35:06 EDT 2014 | maciejbilu
Got it. That make sense. Pick position is quite far from these "normal" one. I ignore the message (and press start button again) every time and the whole mounting process starts normally. JUKI mount every component assigned except one from 44mm feede
Electronics Forum | Mon Aug 06 16:33:52 EDT 2018 | tey422
If I understand customer's intention correctly, it would be fastest, mass production with fully utilizing the Pick-N-Place machine capacity with minimum manual labor which won't break the bank. They used to manual hand soldering the coil to the boar
Electronics Forum | Wed Apr 24 07:06:56 EDT 2019 | griinder
You need two calibration jigs to calibrate these cameras. There is an L-Type align offset jig that involves removing the front feeder base, and placing the target dot over the middle camera of your front camera bank. After this calibration is done, t
Electronics Forum | Mon Jun 10 10:23:47 EDT 2019 | don_julio
We started getting better reflow after rotating the pcb to locate the greater mass closer to the center of the oven. However we still leave space between panels on the conveyor to achieve a better reflow. This costs us production time. I'm simply lo
Electronics Forum | Tue Jan 28 16:47:31 EST 2020 | jede
We are running a Juki SMT line (3RAL and 2080E). I am not sure there is an option for a component verifier. My thought is a barcode/scanner set up and I am in the process of working on this but waiting on Juki response on a file question. We do use
Electronics Forum | Fri May 01 15:35:03 EDT 2020 | travishemen
I'm not sure if these are similar to our Genesis machines but if they have removable feeder banks they are part of the safety circuit. If they are not installed or if the sensors on them are misaligned it will show the same as an interlock violation
