Electronics Forum | Thu Sep 22 13:09:16 EDT 2005 | gregp
Thanks for the reply Rob, This we already do. The machine will pick from the most efficient available feeder (assuming multiples of the same part number)...so when you remove the primary it will seemlessly move to the next available. When you re-in
Electronics Forum | Fri Sep 23 03:11:31 EDT 2005 | Base
Hi All, I think you're adressing this issue from the wrong angle: What I'm reading is an equipment vendor who has an idea about what the best way of working is (replace entire feeders), and a (potential) customer who thinks otherwise (splicing). The
Electronics Forum | Thu Jun 22 15:05:55 EDT 2017 | solderingpro
There are several different technologies in the industry today to assist in the out-gassing of flux cores. On automated soldering systems, there are two main types of perforating solder feeders: - Hole Drilling - "V" Scoring By perforating the so
Electronics Forum | Wed May 24 17:09:05 EDT 2000 | Chris McDonald
We have A V-Tek using pressure sensitive cover tape but the only success that we have found is with SO-8, S0-14, SO-16 anything wider and the tape pulls apart when on our feeders. ANything over 16 wide is not recommened unless you get a heat sensitiv
Electronics Forum | Mon Jun 01 19:04:45 EDT 1998 | Chris
I run about forty different boards ranging from single to double sided & from 0603 to 324 PBGA. 2> The placement rate is around your spec. 3> And depending on the table arrangement you can get up to & above your feeder needs including several soic vi
Electronics Forum | Wed Dec 08 12:58:49 EST 2004 | clampron
If it were my money and I had your specifications to achive, I would go Mydata. One platform, chip shooter, optical centering, mechanical centering, electrical verification (that works)smart feeders that work, etc.... I have worked on several platfor
Electronics Forum | Mon Mar 06 21:58:56 EST 2006 | kent_peterson
Good machine! Just like most part libarys don't let the operators change part profiles. Haven't seen it place 0201's but 0402's have no problem. Tape splicing for the feeders is a problem. The eject wheel gets jammed with anything other than splice t
Electronics Forum | Sat Feb 12 18:35:56 EST 2011 | gabriel1blue
Thank you, that works perfect!! Now I was able to set up the offset's and program the machine, but now head #1 will move to the feeder location but it will not move down to pick up the part, then it moves to the drop area, but its only happening on h
Electronics Forum | Fri Aug 16 15:47:56 EDT 2013 | larrygroves
Hi, I know it's confusing. The 421 is sold with two different vision cameras, standard and megapixel. It depends where you buy the machine. North american machines come with the megapixel cameras standard and will just need a Cn020 nozzle and app
Electronics Forum | Fri Jan 16 12:57:33 EST 2015 | jax
The GSM can place the part from a XY positioning standpoint without issue. You'll have to look at what camera you have to know if the machine can inspect it. After that you need to decide if your feeders can accurately provide the part to the machine