Electronics Forum | Fri Mar 11 14:30:03 EST 2005 | ???
i agree with changing the head board if the ribbon cables have been changed. I would also check the quad align card and make sure the cables are plugged in tight to it and to the backplane. There is a large connector on the backplane that sometimes f
Electronics Forum | Thu Apr 28 04:06:16 EDT 2005 | joseluis_amper
Hello, In my case, the time in change the feeders it's not priority. My production it's very changing, variable, and very little batchs, it's because I select this type of machine, but Assembleon says the same about their machines. What's beeter?, no
Electronics Forum | Fri May 13 11:00:19 EDT 2005 | geb
I have a Universal GSM which won't change nozzles from the changer. It says something along the lines of "timed out waiting for air pressure to build". Even though it has around 100PSI air pressure. Any ideas how to solve this? Cheers
Electronics Forum | Thu Jul 28 18:57:49 EDT 2005 | donb
Hi All, Can anyone tell me if it's possible to change just the ratchet wheel on a Fuji 8x4 feeder to make it 8x2 so we can run 0402 chips, or would we need to change other parts in the feeders as well?
Electronics Forum | Wed Jan 18 17:35:08 EST 2006 | gregoryyork
We manufacture solder and dont charge, so agree with the others and change elsewhere just make sure you are changing to better material if unsure stick with what you have and pay for it under duress. Cheers Greg York BLT Circuit Services Ltd England
Electronics Forum | Wed May 10 12:22:45 EDT 2006 | reg
Hi everyone, I am trying to evaluate the cost of buying new equipment. One of the concerns is blade holders, stencil frames and board vacuum tooling. How difficult is to change from Dek to MPM or viceversa without changing all our tooling.
Electronics Forum | Thu Jul 06 12:26:55 EDT 2006 | Chunks
Sounds like your flux to me. Since you cannot change the board or the machine, changing flux would be one question mark you could take away with a phone call and a sample. You will really be surprised how different fluxes can affect your final prod
Electronics Forum | Mon Sep 11 17:06:53 EDT 2006 | slthomas
1. Change the part. OR 2. Change the pads to Panasonic's recommendation. Actually both are recommended from my perspective. ECHU. Shudder.
Electronics Forum | Wed Dec 20 17:03:50 EST 2006 | aj
By the way , changing the ball screw will also sort your problem out because you will have to carry out the Z-axis setup ( belt tension etc ) as part of the change. so it is worth a shot to carry out the setup and see how it goes! you will have nothi
Electronics Forum | Mon Jan 22 08:02:34 EST 2007 | realchunks
Wow, that must be a lot of HASL to reflow and block a thru-hole. Sounds like your board house changed their process. Contact your board house about this. Change your incoming spec to look for this a well.