Electronics Forum | Thu May 05 19:13:33 EDT 2016 | darby
Thanks Sr. If you have zero tolerance for simul pick up in your component files then you will not have simul pick up due to variances in your head offsets. So you are saying that on your Juki you run a tolerance for 0201? All other head positions at
Electronics Forum | Fri May 06 07:58:33 EDT 2016 | cyber_wolf
Darby, I'm not completely sure I understand. Juki machines have what is referred to as a multi-head. The offsets between the heads are the same as the spacing between 8mm feeders. So the (6) heads all come down at once and "gang pick" from 6 8mm fee
Electronics Forum | Thu Oct 28 11:50:11 EDT 2010 | phase1
We are having a little trouble with what appears to be a crystalization between our fine pitch parts. The problem appears after a a thourough wash of the pcb when dry. It looks like lead wiskers/haze between the joints.We are using water soluable lea
Electronics Forum | Fri May 06 08:27:38 EDT 2016 | kahrpr
We have Samsung and havehad no problems with simultaneous pick ups with 201s 0r 402s. the feeders are durable and do not need much repair especially the sm feeders. The SME feeders have not been out as long so we will see so far so good. As with all
Electronics Forum | Wed Aug 07 08:49:35 EDT 2002 | davef
What do you want to be certified? So, do you have a specification control drawing for each component that defines your expected performance capabilities for use by your buyer in acquiring these parts? If there is a reason to fabricate parts to your
Electronics Forum | Wed Aug 07 11:55:31 EDT 2002 | slthomas
Ron, have a look at http://www.fda.gov/cdrh/dsma/cgmphome.html It would be a nightmare, if your plant is not structured to support it. It's a huge pain in the fanny even when you (alledgedly) are. I'm not sure what you're pursuing, but if you're c
Electronics Forum | Thu May 05 01:50:44 EDT 2016 | darby
Dear Forumites, It's been a while, but I have a question. I was recently asked to provide a scenario on capacity if we retired two older lines and replaced with a new line. My capacity figures were based on real time production over a period of six
Electronics Forum | Thu May 12 00:18:55 EDT 2016 | darby
Sorry for delay - been flat out. Sr - I understand what you are saying. My concern is that combined with the head offsets and variations in pick points (i.e. having to teach feeder positions for very slight amounts like 0.05mm)then you cycle times wi
Electronics Forum | Thu May 30 10:31:03 EDT 2002 | robbied
Hi Yannick. This is an issue that we are just recently getting into but here is some ifo that I have gathered so far. I have seen/ used 2 different rework machines. The one we have bought is a 'PACE TF2000' which was at the lower cost end of the mar
Electronics Forum | Thu Jul 15 16:15:13 EDT 1999 | Doug
| Hi, | | I need some urgent informations on stencil design guidelines on how to perform epoxy printing on 0603 and 0402 components. Could anyone help? ( Reflow process is not possible because of some other constriants) | | Secondly, I need also f
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, USA
Phone: 18002796835