Electronics Forum | Mon Jan 21 11:47:03 EST 2008 | babe7362000
We have a Contact CS400D 1991 series and when I press Control H, it gives me a host error. I can not get it to communicate with the RS232
Electronics Forum | Fri Sep 19 16:16:33 EDT 2008 | davef
We're surprised that your Contact sales representative can't tell you the location of machines near your plant. We expect them to give you a list of customers including address, contact, phone number, and other stuff.
Electronics Forum | Thu Oct 02 16:29:11 EDT 2008 | kiss
Contact your local Fuji dealer. Your questions are covered on first couple of pages of spec. Your reluctantness to contact Fuji direct sounds as though you are a competitor scratching for info. Pick a phone, call Fuji.
Electronics Forum | Thu May 28 06:36:35 EDT 2009 | mitchell
Hello I am a Sales Engineer for Universal in Europe - I have sent you my Contact information by Email - Please contact me - to see if we can sort this out. Thanks
Electronics Forum | Mon Jun 29 19:02:49 EDT 2009 | davef
Current limiting resistor: Personel safety Electrical equipment on the ESD matt: We need more information. Is the equipment ground of the equipment in contact with the matt? Or are the insulating pads on the bottom of the equipment in contact with t
Electronics Forum | Wed Sep 02 01:07:50 EDT 2009 | leadthree
I am looking again at Partminer. Can you filter them to get only in contact with franchised suppliers? We don't want any contact with brokers or traders. We got already too many fake and defects parts from them.
Electronics Forum | Fri Oct 23 16:54:02 EDT 2009 | pnguyvu
FOR YOUR NEXT RUN CONTACT STEVE @ USA STENCILS INC, HE WILL MAKE ONE SAMPLE FOR YOU - THEIR TEAM HAVE SOLID EXPERIENCE IN STENCIL DESIGN ESPECIALLY PCB WITH CRITICAL COMPONENT. HIS EMAIL IS STEVE@USASTENCILS.COM GOOD LUCK!
Electronics Forum | Fri Oct 23 17:33:42 EDT 2009 | grizzy
Check that you are following the moisture sensitivity requirements for the part. I've seen the part swell underneath. You can contact me at wenroth@reconsales.com for more information. I am an 'ol reflow guy from the CM world. Wes
Electronics Forum | Tue Dec 01 14:47:57 EST 2009 | kjs123p
I am wondering what other Conceptronic users are using to oil the chain, lubricate the lead screw, and the grease used on the chain drives. I have contacted Conceptronic, and they gave me recommendations, but I am having trouble contacting them. Than
Electronics Forum | Tue Jan 26 03:12:46 EST 2010 | svebbe
Hi Llew i have tryied to contact you for a service on some machines please mail me and i wil contact you best regards Fredrik in Norway