Electronics Forum | Fri Jan 31 12:22:10 EST 2003 | TN
Many companies used the Fuji CP-4 and CP-6 chip shooters, these are good for the small components like resistors, caps, diodes, transistors and small IC's. If you have BGA, QFP or other larger odd components you will need to go with another type of
Electronics Forum | Thu May 03 13:37:07 EDT 2007 | cyber_wolf
We occasionally have this problem where the nozzles peck little holes in the component overlay tape causing it to break. It only happens on universal tape covers. We see it on our CP4 and CP6 machines. Has anyone else experienced this ?
Electronics Forum | Wed Dec 17 12:51:56 EST 1997 | Mike Cox
Anybody have one of these machines feel free to call or email me Mike Cox 1-208-887-1000 MCCOX94@AOL.COM Thanks for your help
Electronics Forum | Tue Dec 14 16:46:28 EST 1999 | K3 Equipment
Larry, Most likely coming from L & M guide at placing station. Depending on size of bearing, also could be bouncing up from z axis.
Electronics Forum | Fri Dec 03 08:06:23 EST 1999 | Mark Anderson
Firstly, Verify your Z-height per the procedure in the Maintenance manual. In general, release the placement stopper and rotate cam onto flat surface of board with z-axis at zero. There should be 0.15 mm compression of the spring
Electronics Forum | Sat Dec 04 12:47:36 EST 1999 | Robert Halliday
Run a DTI over the X and Y edges of the table to ensure that your XY table is flat, adjust the four small screws to suit. Also check that the Z cams are not worn and that the Z cam followers are not siezed or worn(they are prone to flat spots when wo
Electronics Forum | Wed Nov 24 06:38:57 EST 1999 | carl
Hi Larry; Have you tried just to place it as a square. Or if all fails try vision 254 255. Just be carefull with this as it will place nothing if the reel runs out. Give me a call.
Electronics Forum | Tue Nov 30 14:47:34 EST 1999 | EmJay
Larry, TRy using #254 and front light the part. When you define the leads leave plenty of tolerance and use a P-Pattern of 34.
Electronics Forum | Tue Sep 14 12:39:27 EDT 1999 | Jim Trent
Is it possible to place 0402 components with a Fuji CP2? How about a CP4? What are the suggestions for 0402 machine placement? Any help would be appreciated.
Electronics Forum | Tue Sep 14 17:56:56 EDT 1999 | Mark Deren
| Is it possible to place 0402 components with a Fuji CP2? How about a CP4? What are the suggestions for 0402 machine placement? | | Any help would be appreciated. |
.gif)
winsouce.jpg)