Electronics Forum: cutter (Page 10 of 19)

RoHS Tool kits

Electronics Forum | Wed Nov 14 20:06:20 EST 2007 | petep

I would like a nicely packaged set of assembly tools (green handles and pouch) for use with RoHS assemblies. I have Green mats, dedicated irons, but would like clearly identifiable tools to better segregate the process. Can any of you provide a Man

PTH lead milling

Electronics Forum | Tue Feb 19 14:52:04 EST 2008 | dphilbrick

You also need to understand when using something like a Q Cutter you should resolder the board after you cut! Your alternative is to get someting that when you put your part in it cuts and clinces the part. Contact Systems makes machines that present

Min spacing for land patterns from PCB edge

Electronics Forum | Wed Apr 09 14:50:03 EDT 2008 | bradlanger

We use a FKN pizza cutter and found that even with 5mm clearance and the proper orientation of the part larger ceramic capacitors 1812, 1210 would still stress fracture. We have successfully fixed stress fracture problems by adding routed relief slot

Who makes the best after market Fuji nozzles ?

Electronics Forum | Tue Dec 16 22:38:51 EST 2008 | ashley

Hello Sr.Tech, Please write direct to apexservice@apexsmt.com I am sure they are able & willing to provide to you sample nozzles for your evaluation. Just let them know the sizes that you need. Apex SMT in Singapore is also be able to support other

Stencil Cutters

Electronics Forum | Wed Nov 19 17:29:05 EST 2008 | elias67

It is not as easy as just buying a Laser machine. There is much more involved in bringing this in house. With the price of stencils these days, you would have to be consuming a very large amount of stencils to justify such an investment. Steve is r

Stencil Cutters

Electronics Forum | Thu Nov 20 09:49:25 EST 2008 | slthomas

"Jeez, how do people like this make it to power?" lol...there goes Hussman, saying what everyone else is thinking. I do like robgd3's line of thinking. If you want to spend money, why not spend it on a machine that replaces* stencils instead of one

Multilayer Ceramic Capacitor (MLCC) failure root cause analysis

Electronics Forum | Wed Aug 22 13:18:50 EDT 2012 | rway

I also forgot to mention that the pizza-slicers you are using can get out of spec and may need periodic calibration. By cutting too close, these can over-stress your pcbs as well. Do you only see this problem at one cutter or does it matter? Also,

Mechanical Delamination at de-panel

Electronics Forum | Tue Jun 03 10:28:09 EDT 2014 | swag

Incoming inspection: Look for flaws and measure position of v-score as well as depth. If v-scored on both sides of panel, make sure v-scores are in alignment. Follow the PCB thru all processes inspecting after each stage of processing, especially

Low Tack Double Sided Tape

Electronics Forum | Fri Jun 03 09:37:59 EDT 2016 | sumote

Same here. Buy it by the 2-pack at Staples. If the tape does not get used often we pull off about 5 inches and discard before we use it. The exposed tape between the cutter and the roll, and 1 rotation around the outside of the roll attracts dust and

Depanalization of CEM-1

Electronics Forum | Wed Feb 14 16:38:00 EST 2018 | cbart

i have seen that happen when the wrong process was utilized! your boards looked like they were v-scored and someone broke them apart, proper method would be to use a scoring separation machine.. pizza cutter. this would prevent this. its not a good i


cutter searches for Companies, Equipment, Machines, Suppliers & Information