Electronics Forum | Wed May 16 00:14:45 EDT 2018 | leeg
We have a Dek Horizon and we have started getting a data file open error when trying to save files. This is resulting in us having to re-teach board fiducials etc in every time we switch back to a previous job. Any ideas?
Electronics Forum | Fri Sep 26 12:26:16 EDT 2008 | dwelch123
Isn't that what I just said? Read it again. I said you can swap zero and one OR two and three.
Electronics Forum | Thu Sep 25 16:23:42 EDT 2008 | aj
Hi, Have you tried to download the MINT ?if this works you should be back in business , if not,check your PSU, which you can access from the back? check the manual as to which one powers the cards- dont have manual to hand but I think it is the 5v
Electronics Forum | Fri Sep 26 08:11:15 EDT 2008 | dwelch123
Try swapping cards in Y1 enclosure. You can swap zero and one or two and three but make sure you change the shunt position and the dip switch settings and see if your problem switches cards. The lithium battery likes to fail on those cards. Reload th
Electronics Forum | Thu Feb 14 13:10:58 EST 2013 | markhoch
I had this problem once a loooooooong time ago with a 248 that was at my previous place of employment. If I remember correctly, my issue was caused by a set screw on the drive gear that had worked itself loose. My issue was stright forward and quickl
Electronics Forum | Fri Feb 15 21:52:06 EST 2013 | nikyta
Most likely it is a faulty cable in the e-chain . You can test it in diagnostic: lower the back squeege and manually move back and forth for its entire travel the print carriage while monitoring the sensor output of the squeege. You will see at some
Electronics Forum | Fri Sep 26 12:16:52 EDT 2008 | bickt
you cannot swap 0-3 only 0-1 or 2-3 they are not the same euro cards. they function very diffrently. if you look you will see there are more chips and circuitry on one set. there are 2 w/red leds and 2 with green leds. at least thats how they soo
Electronics Forum | Wed Jun 19 11:26:06 EDT 2019 | key
We have been looking at the Sol for the in and out and the up and down for the blades. We moved the sol around with no change. where is the RS cylinder located in the DEK 248.
Electronics Forum | Mon Jun 04 09:20:38 EDT 2018 | dekhead
>> mis-alignment?
Electronics Forum | Thu Jun 13 20:03:05 EDT 2019 | dekhead
Does it cycle in/out in diagnostics? Have you checked pneumatics to to the RS cylinder?