Electronics Forum | Thu Jun 13 03:34:58 EDT 2002 | genglish
Can anyone tell me where I can get these frames repaired (bladder failure) other than DEK, we are looking at reducing the cost as DEK is quite expensive. Regards
Electronics Forum | Thu Feb 17 17:33:34 EST 2022 | mnorthey
Hi all, I have a Dek 265 Horizon that fails to print at the correct pressure. It fails pressure every pass. I am trying to Calibrate it with a PFR1200N pressure Tester which we use for our DEK 248 Printers. I am trying to build up the table height
Electronics Forum | Thu Oct 26 12:14:34 EDT 2017 | lefwan
Our DEK 265 machine is showing this error message during starting…than it keeps re-starting in endless loops: Diskette drive failure on drive A Fixed Disk Controller Failure Fast ready check - Version 1.0 Copyright Arcom Control Systems Ltd. CMOS
Electronics Forum | Thu Jul 16 12:32:59 EDT 1998 | Earl Moon
Howdy 2, I am using my first DEK GSX PRINTER. Looks and acts good so far. Who know what - good, bad, or in between? Just want to get the facts from those who know. Earl Moon
Electronics Forum | Thu Feb 21 16:53:32 EST 2019 | bane016
I don't know...but at DEK horizont i2 , i3 and ASM have option in machine settings "print/no print....if you check "no print" machine work in passthrough mode...
Electronics Forum | Tue Mar 02 12:50:12 EST 2021 | ttheis
I have a parts 265 horizon if you want it. Was told it needs a front rail sensor but lmk if you are interested. Will sell cheap, located in milwaukee area.
Electronics Forum | Tue Mar 29 14:43:50 EDT 2022 | padawanlinuxero
Hi! Looks likely you have a calibration problem with the vision system, since is a 265 if possible try to restore a backup on floppy if not rerun the calibration procedure
Electronics Forum | Sat Mar 05 14:41:52 EST 2005 | Velocidog
Anyone have any they aren't using anymore or know where I can buy some second-hand or aftermarket? Thanks
Electronics Forum | Fri Mar 11 09:38:26 EST 2005 | cbarnett
I would suggest that you make pins in house, we are currently making pins & blocks for board support.
Electronics Forum | Mon May 05 15:52:22 EDT 2008 | dekhead
Assuming you have the scale that corresponds with Board Width for center justified stencil. Formula would be: 2 x (distance to image {mm} - 368) = Board Width (setting on scale) http://www.dekhead.com/