Electronics Forum | Thu Mar 02 17:32:09 EST 2006 | sphilips
The initial cost of the battery is similar to saying the size of an iceberg is measured only by what shows above the waterline. There is a lot more to it than at first blush. The ECD Power Pack costs $245, but provides over 3500 hours of profiling.
Electronics Forum | Mon Oct 26 19:48:14 EST 1998 | Scott B.
| | What are the key feature to look for in buying a profiling product for Reflow ? | | | | Who's is the best and how much do these systems cost ? | | | | Thanks in advance. | | | | Hi Mark, | | I am currently the oven sector engineer for a larg
Electronics Forum | Mon Jan 28 15:34:19 EST 2008 | slthomas
I have used the ECD MOLE and had no complaints. I also checked out a Datapaq at one time and really liked the software but it was a little on the spendy side. ECD provides free upgrades to their software which does provide some fairly helpful pred
Electronics Forum | Thu Apr 12 15:16:35 EDT 2001 | Rex Breunsbach
Profiles design is primarily determined by oven geometry, paste specifications and component thermal limitations. This means that no one "standard" profile exists for all production. A free profile planning utility can be quickly downloaded from
Electronics Forum | Mon Feb 13 13:19:35 EST 2006 | pjc
ECD's OvenRIDER is the only instrument I know that can measure thermal transfer efficiency of a an oven. I suppose it would work for environmental chambers too. This instrument has thermocouples to measure ambient temp of oven zones and well as hi-ma
Electronics Forum | Fri Mar 19 07:24:29 EST 2004 | pjc
Before "Pb-Free" became an issue we were and still are using Pb-Free component lead finishes- such as on many TSOP, SSOP and QFP packages as well as caps. Components manufacturers changing the lead finish to no-Pb tend to ensure solderability with Sn
Electronics Forum | Thu May 26 15:59:40 EDT 2005 | davef
Let�s not get drawn into making more of the amount of training required in order to be able to develop an effective reflow recipe than is necessary. A low-skilled operator with about one hour's training can setup the solder reflow oven. Consider co
Electronics Forum | Mon Feb 20 14:49:58 EST 2006 | pjc
Samir, I didn't get the e-mail unless I thought it was spam and erased it. The high-mass sensors are custom made for ECD. The round sensors on the OvenRIDER are the "process" or high-mass sensors. They are designed to never reach zone temnperature. T
Electronics Forum | Fri Mar 03 20:45:58 EST 2006 | KEN
I have used KIC data acquisition equipment for over 11 years. Slim kic, sideKic and Kic2000, prophet etc... The 9 volt battry changes in seconds. Gimme a break. The internals don't reach 54Celsius. If it came down to batteries, I bet KIC would t
Electronics Forum | Tue Oct 27 04:19:40 EST 1998 | Mark
| | | | What are the key feature to look for in buying a profiling product for Reflow ? | | | | | | Who's is the best and how much do these systems cost ? | | | | | | Thanks in advance. | | | | | | Hi Mark, | | | | I am currently the oven secto