Electronics Forum | Tue Jul 31 22:32:35 EDT 2018 | dekhead
Hardware dongle on back of machine is software key which may or may not be required for your software (depends on software version) and has nothing to do with the error you are experiencing. The hardware link to which I refer is on the Y1 backplane
Electronics Forum | Mon Jan 06 11:41:52 EST 2020 | robl
JDT http://www.DEKHEAD.com if you are in the USA Adamtech http://www.adamtech.co.uk/contact.asp if you are in Europe There are some good Chinese suppliers, but a lot of Far East cards can be tarnished & with a reduced life due to running in a high h
Electronics Forum | Mon Jan 06 16:19:32 EST 2020 | richardcargill
haven't tried the MINT as it won't let me get that far !! Swapping the Eproms with card 1 and changing the identifier will let it get to the 'Press SYSTEM key' part of the startup though, then it fails on card 1 instead of 0 so I'll give that a try i
Electronics Forum | Mon Dec 22 08:20:34 EST 2003 | kauerr
Hi,I am a Mfg. Engineering Tech. and do Maintenance on all of our Equipment. 4796 HSPs, Dek 265 LT screen printers, GSMs, ect. We have 6 lines of equipment with certain operators assigned to each line, and you can really tell which operators do or do
Electronics Forum | Tue Jan 30 14:18:22 EST 2024 | spoiltforchoice
It might be worth mentioning that Speedprint (now Europlacer) printers also have a calibrate using your own board capability. They arguably also target higher mix environments given that is the market the pick and place machine targets. DEK uses a v
Electronics Forum | Sun Jul 18 12:13:06 EDT 2021 | oriolsancheza
Hello, Our machine started to not stopping board into the right position (stop pin was not working we guess). After some inspection we have not seen anything strange. However the DEK software decided to not work anymore. We've been messing arrounf
Electronics Forum | Mon Sep 03 04:05:56 EDT 2012 | omur
The issue has finally been resolved. It turns out that while checking the vision board, our engineers accidentally changed the address of the Analogue Board (which is adjacent to the vision board) - thus, leading to this startup error - with the unh
Electronics Forum | Fri Sep 14 10:30:45 EDT 2012 | dekhead
I believe there was a software issue as well; Initially installed software (4.03) replacing existing 2.12. After that it got past the "Stack Overflow" and displayed the expected error for incorrect addressing on PCAD12... BTW solution to "vision boa
Electronics Forum | Wed Aug 24 05:23:45 EDT 2016 | bukas
hello, DEK wont start and im getting this error message: motor com error, axis 1,2,3 fatal error, reinitialise machine. this happens about 30 sec after BIOSes are copied to shadow ram. euro sys cards are inserted properly and on segment display is s
Electronics Forum | Sun Mar 07 21:26:54 EST 1999 | Chris G.
| My printer evaluation has come down to the Fuji GP-6 or the Dek 265LT. I'm looking for experienced opinions on both of these options, we're currently running an older vintage Dek 265 printer that gives us constant electronic system problems. The v
