Electronics Forum | Fri Oct 05 18:59:53 EDT 2001 | Dan Steffler
I have had an issue where solder has contaminated gold plated pads (fingers) where it is not acceptable. The pads must remain perfectly coplaniar for a LCD zebra strip to lay accross them. Does anyone know of a way to remove the marriage level of s
Electronics Forum | Tue Jun 28 18:20:49 EDT 2005 | russ
Matt, have you run a profile on this board? Just because it's .062" doesn't mean that any old .062" profile will work. We have .062" thick boards that almost nil for copper and other are utilizing 2 oz. layers internally. They require quite diffe
Electronics Forum | Wed Dec 13 12:08:57 EST 2000 | Stefan Witte
Apparently the adhesive tape peels off from the joint, which could have some reasons. 1. There should be an overlap of the cover tape, as Cal mentioned. The new cover tape laying over the old by approx. 2mm. I also peel the cover tape a bit off, whi
Electronics Forum | Wed Sep 18 22:53:24 EDT 2002 | davef
Please give us background on your situation, so that we can focus on the specifics, for instance: * This is a bare board problem, correct? Then, this contamination causes what the problems in your process? * What is the type [ie, FR4, CEM1, etc] of
Electronics Forum | Wed Sep 18 22:10:48 EDT 2002 | Joe Wong
I'm working China ,in my working factory is a electronic OEM factory and got COB and SMT. But recently, COB got a big problem because the PCB gold finger got a contamination, that make us got a most defect product. So anyone can answer me how to clea
Electronics Forum | Thu Oct 07 20:34:48 EDT 1999 | Tony Huang
Hi, Does anybody know what is the minimum gold plating thickness on the PCB goldfinger required by the industrial specifications - IPC, Bellcore, etc. Where can I find the information? Appreciate for the help! Thanks, Tony
Electronics Forum | Thu Sep 19 20:28:59 EDT 2002 | bugsjoe
* What kind of the eraser can clean clearly?I've been use the eraser but the defect still present.
Electronics Forum | Thu Sep 19 21:17:50 EDT 2002 | Sam
We had encountered similar problem before. But the cause was found out to be the poor good plating, instead of contamination. The way we dealt with that was sending them to the supplier for rework. It may be the fastest and most relaibility way. Goo
Electronics Forum | Thu Sep 19 21:26:52 EDT 2002 | davef
Sam, You're correct. And that's what Joe would prefer to do with his contaminated boards, but he's trying to keeping line running, I believe.
Electronics Forum | Fri Oct 08 17:12:31 EDT 1999 | Dave F
| Hi, | | Does anybody know what is the minimum gold plating thickness on the PCB goldfinger required by the industrial specifications - IPC, Bellcore, etc. Where can I find the information? Appreciate for the help! | | Thanks, | Tony | Hi Tony: