Electronics Forum | Mon Jan 26 03:45:37 EST 2004 | Vinny
Hi All, We are producing a veriety of RF related PCBAs in which we see Unsolder/Mislaigned on a regular basis. In these baords usually one of the pad is connected to a signal trace and the other pad is connected to very huge ground plane. This gro
Electronics Forum | Wed Oct 15 17:40:42 EDT 2008 | bandjwet
Dear SMTNetters: What are some favorite techniques for getting all of the solder from a plated throughhole on a heavy ground plane area? We are using a SAC 405 alloy. Regards BWET
Electronics Forum | Fri Jun 17 13:51:21 EDT 2011 | mosborne1
Your problem is at your board house with the finish. There is not enough tin deposited on the ground plane. Could be the current density too low on the ground plane. If electroless they just didn't process these correctly. What is the finish suppose
Electronics Forum | Wed Dec 10 16:15:24 EST 2008 | terryl
on the front end in design, minimize the pth connections to ground planes. this takes alot of work by the pcb designer and the approval of the design engineer. connect maximum of 4 ground planes to pth, minimum 1 plane. use spoked connections. ev
Electronics Forum | Fri Nov 15 11:03:48 EST 2019 | rgduval
I think Steve is on to it. The wire is not getting hot enough to wet. Either the solderer is attempting to solder too quickly, or the PTH is connected to a ground plane. The solder sticking up through the hole leads me to think it's connected to a
Electronics Forum | Thu Feb 08 08:20:52 EST 2007 | mzaboogie
tjc, Is this pin connected to a heavy conductor or ground plane? Chris
Electronics Forum | Thu Feb 08 08:33:08 EST 2007 | jdumont
Most likely ground plane stealing your heat. Increase dwell slightly if you can.
Electronics Forum | Fri Sep 12 09:33:18 EDT 2008 | realchunks
When you sat design problem, is it a because there is a ground plane causing a thermal problem?
Electronics Forum | Tue Sep 24 10:09:52 EDT 2013 | leigh
Windowpane your ground planes, this will prevent a lot of voiding.
Electronics Forum | Tue Jul 27 08:55:21 EDT 2004 | Cal
CJ- If I am not mistaken the Zephytronics machines have a money back guarantee if not satisfied. We have boards with huge ground planes and the air bath is the only rework that can do this. We also have found heat guns get hot enough but the heat is