Electronics Forum | Mon Jun 30 00:50:57 EDT 2008 | benefon
Hi There are many ways of doing this but I usually transpose the coordinates to the lower right hand corner of the sub-panel that is situated at the lower right hand corner, because the reference point of the machine is the right hand side locate pi
Electronics Forum | Wed Apr 27 11:13:41 EDT 2011 | jhinckley
I have a 1800w that the main contactor will not pull in. When i push the contactor in manualy the power goes through but nothing turns on, when i push in the fan contactors all fans come on. The programs seem to load butnothing happens and the sp and
Electronics Forum | Mon Sep 15 10:28:15 EDT 2014 | jacky3855
Our company is one of leading Electronics components distributor.We sale IC(Integrated Circuit),Modules,Capacitor,Connectors etc, Any other goods do you need? Yours Sincerely Brenda HongDa Electronics Co.,Ltd http://www.ic-hongda.com Email
Electronics Forum | Tue Oct 14 08:27:32 EDT 2014 | kkay
We use a few different style of press fit connectors, terminals, studs, etc. We use a tabletop arbor press for most everything we do, but a lot of times we will see some measling or slight delamination around the holes for the press fit part. Is ther
Electronics Forum | Tue Oct 14 10:21:44 EDT 2014 | fredc
Accuracy of the arbor press might be made better by tightening the adjustable gibs on the ram if any. If you can use support under the board have the ID of the support just slightly larger than the pins being pressed. Janesville Tool makes an accura
Electronics Forum | Fri Oct 28 17:50:17 EDT 2016 | ttheis
Found a broken wire in the data line and I thought that was it for sure but was not. Checked continuity of the data cable and it is ok now but still no comm. The embedded controller status window shows "send failures" but no "reply failures." Winco
Electronics Forum | Wed Jun 06 10:59:43 EDT 2001 | wbu
It�s hard to tell you one good profile for a specific machine cause profiles are mainly dependent on the specific assembly you want to rework. My aproach to this problem is trying to get a close as possible profile as under normal reflow conditions u
Electronics Forum | Wed Jun 06 13:38:15 EDT 2001 | Michael Parker
To expand on Wolfgangs reply, I suggest you contact your local SRT rep. We recently had the same type of problem as yourself. This is the path we followed. Arrange for operator training, for yourself first, then the operators after you get the machi
Electronics Forum | Fri Apr 02 15:41:38 EST 2004 | azdback
You may also want to start on the component library. Hypotetically speaking, the GSM shows the component as follows in the component library: One lead to the right, 3 leads to the left. This is the feeder default orientaion and it will be 0 degrees.
Electronics Forum | Wed Apr 07 18:47:23 EDT 2004 | pdeuel
Thanks to all of you. As it turns out,(pun), the problem was with optimization. The SOT-63 Was being picked with other parts also set to pre orent when orignally this part was not. The program was then optimized. The other parts on the other heads ca
