Electronics Forum | Mon Jun 26 09:33:07 EDT 2017 | bobpan
So I am assuming that you are using the IQ feeders option on the machine. First thing I would check is to make sure you don't have an older feeder on the machine. There was a certain point where quad feeders would be 'IQ' capable or not. You may have
Electronics Forum | Wed Jul 03 06:52:27 EDT 2019 | bobpan
Seems to be fighting to hold its position. 1. Check for anything worn out...possibly idler bearing/pulley and/or the belt. 2. Maybe it could use servo tuning...this may help but usually servo tuning is not that critical. 3. Clean the scale and the
Electronics Forum | Wed Dec 20 10:04:07 EST 2017 | junkeymonkey246
Hello there, I work at Redcom Laboratories in Victor NY. I'm a student and new to being a machine repair technician. I'm having some bother with one of our TYCO QUAD QSP-2 machines. I keep getting the errors: "WARNING: Head#2 Nozzle RUNOUT=27.1 mi
Electronics Forum | Thu Jun 03 13:11:02 EDT 2004 | Scott B
We had an existing Mydata MY15 line and inherited 2 Quad lines (QSP2 and QSX1). We eventually had to get rid of the 2 Quads (major software and hardware issues) and have replaced these two machines with an addition single Mydata MY15 and are getting
Electronics Forum | Fri Apr 07 16:12:37 EDT 2006 | craig_83
I would like to freeze feeders on a global basis. I am tired of table changeovers everytime I run a different board. A good example is today I ran 1 board which went well. I wanted to run a board behind it that had 99% the same parts. I am not necess
Electronics Forum | Wed Dec 30 12:58:10 EST 2009 | vetteboy86
I'm setting up a matrix tray for the first time on our Quad QSP-2. I believe I have defined the tray and holder. Assigned part numbers. My issue is that instead of teach feeders, I think I need to teach table top. When I do this, I am not finding an
Electronics Forum | Mon Oct 09 06:04:47 EDT 2017 | bobpan
Hello Joyce, Usually I use Very Large cable ties and secure the heads in the opposite corners. I also tie up the z rods or put some plastic tube under the top portion to keep them up. Remove the monitor and bracket off the side of the machine...and i
Electronics Forum | Wed Jun 19 10:40:07 EDT 2019 | bobpan
The only thing left is the read head. Older read heads tend to 'weaken' with age. Sometimes some engineers will shim them up closer to the scale using a 10 mil shim. You could also swap them between gantries...i dont think they are to tough to get to
Electronics Forum | Tue Jul 31 20:38:49 EDT 2001 | jbull
Does any have any experience with Multitroniks pick & place machines. How do the machines perform for accuracy, repeatability, programmability and serviceability? Does the machine have a good uptime record? How is the service & support? I ask these q
Electronics Forum | Thu Jan 16 18:14:35 EST 2003 | jonfox
You can still get support. I was in that deal before Tyco decided they didn't need Multitronics field engineers playing with Quads. Anyway, most of the original Quad personnel are stil running service. Based by region, in the West or Central US, c