Electronics Forum | Wed Dec 21 08:55:58 EST 2005 | russ
Most likely the temp controller itself if all of the above mentioned are fine.
Electronics Forum | Fri Jan 20 09:17:59 EST 2006 | George
Hi "theSaint", We are using SN100C in our wave solder machine. As far as the solder itself, the wave process follows pretty much the same concept as leaded solder. You bring the assembly temp to 90 C or more before the actual wave. Sometimes for mul
Electronics Forum | Mon Jul 01 16:34:46 EDT 2013 | wpierowski
So that is common when the temp on the wash is high? The temp was adjusted for a flux that required a higher temp. How much of an issue is this tin oxide?
Electronics Forum | Fri Sep 21 09:29:49 EDT 2001 | steven
when taking a reflow profile, can i attach the thermalcouple to the component body (using high temp tape) instead of to the leads (often found thermal couple dettached during reflow). in general, what is the temp diff between these 2 locatinos. if so
Electronics Forum | Fri May 26 10:49:32 EDT 2006 | pjc
250C peak temp seems very high for components. Thermal damage, which is latent like ESD damage, can occur on components at temps as low as 235C. Looking at component specs to see what the max temps are is a good idea I think when doing Pb Free trials
Electronics Forum | Sat May 26 00:32:55 EDT 2007 | crashoveride
it'll be cheaper if you'll let your wave machine up all night and let it in its idle temp (supposed to be 200��C) simply because it will need less power from idle temp up to operational temp compared to from 0�C-operational temp. Temperature Sensors
Electronics Forum | Wed Aug 24 09:21:45 EDT 2011 | blnorman
We always used a MOLE on our wave ovens. From what I know of temp dots, they let you know if a temp has been exceeded. The IR gun we had also had the limitation that the further away from the target, the broader the area being analyzed. Guess it b
Electronics Forum | Fri Nov 03 13:48:39 EST 2006 | monty
I have a BTU Reflow 8 stage (PCDIU software) oven. The max temp. that it will allow is 270 degrees. I am trying to use a High Temp solder paste and the profile states that I must go between 260 and 270 degrees. My question is, is there a way to incre
Electronics Forum | Thu Nov 17 13:13:49 EST 2005 | Mike
Hello, Some questions.... Are you running lead free? What alloy? What�s your pot temp at? Temp of the board after preheat? Are you getting any solder in the barrels (
Electronics Forum | Thu Nov 02 20:38:32 EST 2006 | Sxsxcx
Which solder did you use? What process? Just hand soldering? I think 750~800 temp. maybe so so so so high!!! Normally, we set irons at 350~400 degC temp. for our common hand soldering.
