Electronics Forum | Fri May 17 11:36:37 EDT 2002 | Hussman69
Hmmm... Why would you want to to this? I understand your concern, but why not let your stencil house manipulate your Gerber and send you a copy of it before they cut a stencil? Saves you time and money. Sit down with your stencil manufacturer and
Electronics Forum | Thu Jan 09 21:19:49 EST 2003 | caldon
Let me through my hat in the ring...I know this is not the forum but what the hey. I have to much experience to list. Just email me at cal_driscoll@hotmail.com. DAVE F. FYI- My comments on here will be from me as an independent as I was let go from
Electronics Forum | Wed Dec 11 11:55:54 EST 2002 | larryk
Lets take it a step farther. What about letting them use tapes or CDs in those walkmans? Would you allow them on the factory floor? Any ESD issues with the plastic cases? If not, would you limit the amount of tapes or CDS they could have with them?
Electronics Forum | Thu May 01 09:02:55 EDT 2003 | ehess
we have used board mask that we let dry. It's tricky to get it flat with no spikes, but after a few tries you'll get it. I like the guys recommendation to try paste and let it dry. we have that problem when the operators do not clean the stencil p
Electronics Forum | Mon Sep 27 20:40:05 EDT 2004 | danhui888
Hi, You may look into PVA 650 which cost around US$40K for a unit. Let me know which company you are or which location will you be and I shall get my team to visit you and let you know more about this sysytem. Regards Danny Hui
Electronics Forum | Wed Dec 14 07:46:41 EST 2005 | chunks
Yup, I saw the original question too. I just can't see how any one would let a stencil manufacturer dictate their processes. Maybe if your designs are small and straight forward, but are you really going to let a stencil maker tell you what product
Electronics Forum | Sat May 26 00:32:55 EDT 2007 | crashoveride
it'll be cheaper if you'll let your wave machine up all night and let it in its idle temp (supposed to be 200��C) simply because it will need less power from idle temp up to operational temp compared to from 0�C-operational temp. Temperature Sensors
Electronics Forum | Tue Jul 01 12:21:16 EDT 2008 | short_timer
Let�s say I want to increase the shear strength of a solder joint. Does a lot of solder around a joint create more strength? Why not just absolutely bury the component lead in solder. My initial thought is that it doesn�t increase strength, but I don
Electronics Forum | Thu Dec 04 12:24:35 EST 2008 | jdumont
We have the same Asymtek machine, same Humiseal product, same bubbling issue on touch ups. Ive found that very light pressure and a thinner mixture usually yields good results for us. Generally I dip the brush in the mixture and let it drip near wher
Electronics Forum | Thu Jan 29 00:12:39 EST 2009 | grayman
Hi Armando, I think you have to buy a bigger reflow let say 7 zones to get the correct profile. The reason you are getting that problem is due to short profile time. What is the size of your board? What is the composition of your solder paste? Ple