Electronics Forum | Fri Oct 28 08:37:06 EDT 2005 | pavel_murtishev
Once again, it isn�t the process problem. It�s machine problem. I�ve tried to change all of the parameters: printing speed, printing pressure, snap-off speed, snap-off distance, etc. No any effect. Defect still exists with different process parameter
Electronics Forum | Wed Nov 02 08:21:45 EST 2005 | chunks
Yes, I agree, manual cleaning is not a solution, but does tell you you need to clean the stencil. You should have your stencil cleaner repaired and take that question mark away. Once all the question marks are goen you should be left with an answer
Electronics Forum | Tue Aug 29 15:05:16 EDT 2006 | cyber_wolf
We run a lot of double sided boards. So I need a printer that will handle warped boards well. Can anyone tell me which printers work better on warped boards ? Our AP25's are crap on warped boards. If I had a penny for every time our cameras got kno
Electronics Forum | Fri Sep 22 14:07:29 EDT 2006 | realchunks
I think Sr is right. Miss prints are prolly a result of your tooling moving the board after the camera looks at the fids. It also could be the camera itself hitting the board from warpped board or tooling raising the board up. It may be the camera
Electronics Forum | Mon Sep 25 09:47:34 EDT 2006 | SWAG
Not sure if this will help at all but you might try doing a lighting histogram test/adjustment since you have a new camera. It could be that your lighting is very bright or too dim and the camera is confusing features next to your intended fiducials
Electronics Forum | Sat Aug 04 08:09:03 EDT 2007 | rich7799
I found the problem... the vx cable trunking was the wrong radius, so when the axis was moving at slower speeds to read pre stop position, the axis was not reading the platen correctly due to extra downward force.. Ive now replaced the trunking and
Electronics Forum | Thu Sep 20 23:10:11 EDT 2007 | valuems
You have a AP that needs to have the calibration and I expect you need to replace 1 or maybe 2 cards replaced. You probly got water in your air supply. The calibration will not be a easy one and special tools are needed. You can call us if you wis
Electronics Forum | Tue Mar 11 13:12:56 EDT 2008 | swag
Careful when you get them! I ordered some overnight some time ago because I was too disorganized to have spares. An operator set a heavy steel vise base on top of the bag-o-bulbs while I was taking off the camera cover and crushed all the new ones.
Electronics Forum | Sun Jan 13 17:09:58 EST 2019 | sarason
Attach a 3V cell using jumper clips to your existing cbpard, then swap out the dieing cell. if you are lucky you may be able to continue without having to find hat floppy disk. You will still need to know the PW: Given that this is basically an old P
Electronics Forum | Mon Sep 20 11:53:41 EDT 1999 | Scott S. Snider
| HI everyone, | | We are using a Siemens ap-25 screen printer, in the past we have not had any problems with adhesive placement until a couple of weeks ago. It seems the x axis has decided that it should be set somewhere between .00085 and .001
winsouce.jpg)