Electronics Forum | Thu Jun 04 11:09:50 EDT 1998 | Justin Medernach
| I have gold fingers that I want to mask when running over the wave without pallets. They're on the leading edge of the board. I recall seeing rubber boots that slid onto the fingers to mask them. Pop 'em on before the wave; pop' em off after and
Electronics Forum | Thu Jun 04 09:53:31 EDT 1998 | Dave F
| I have gold fingers that I want to mask when running over the wave without pallets. They're on the leading edge of the board. I recall seeing rubber boots that slid onto the fingers to mask them. Pop 'em on before the wave; pop' em off after and
Electronics Forum | Thu Sep 13 17:57:59 EDT 2001 | davef
You're correct. It is curious. Possible angles to look at are: 1 WS609 loves moisture in the air. In high humidity shops, this paste hakes-on liquid. If this is the case, you should also see slumping, resulting in fine pitch bridging, and solder
Electronics Forum | Wed Sep 25 13:12:25 EDT 2002 | dragonslayr
Dave (and Brian) - OK, following the logic of your post above sounds good. I now have questions. How would a user know to follow your suggestion? Especially a newbie? How would a new posting be titled so that it has relevance to a "locked" thread?
Electronics Forum | Tue Aug 23 22:50:09 EDT 2005 | adeline_ko
My process guy told me that. Due to black spot issue, brd with BGA must use electrolytic finishing. And when we had this finishing with plug via, the blister issue pop out. My supplier claim that this is due to the plug via. Which I don't know how
Electronics Forum | Fri Dec 21 15:50:54 EST 2007 | rwyman
Hi smtdude- I'm no expert at PoP (yet!) as we've only done a few weeks worth of experiments for a new customer but what i can tell you is 25-50% of the ball height (not diameter) is a good rule of thumb for the flux depth, at least to start. I can s
Electronics Forum | Mon Jun 05 18:50:10 EDT 2017 | caurbach
Hi Zac, My 2 cents: We had similar problems on a board in the same situation (tin-lead HASL, very long leads, low pot height, high pump RPM). Trimming the leads shorter, moving the pot closer to the board, and dropping the pump speed down to sane
Electronics Forum | Wed Aug 16 18:24:58 EDT 2000 | Boca
Does anyone else have the 'form tips' pop up over and over and over and over.. well you get the idea, after looking at each form entry. This has happened many times over the last several weeks. It does this to me after I obediently check the 'don't
Electronics Forum | Fri Jun 23 10:01:35 EDT 2000 | Bob Willis
A couple of weeks back I produced a video clip for Metcal to show what happens when BGA pop or the edge of the base warps causing shorts to form. Its 2.3meg if there is enough interest in seeing this I will put it up some where for download. Bob Wil
Electronics Forum | Wed Dec 20 14:26:47 EST 2000 | Charles Harper
One of my chapter authors,Dr.Rolf Funer teaches a course specifically on evaluating and qualifying new PCB suppliers.Hence,he can give the best and most complete advice here.So,just click on his name in the list of chapter authors at the top of this