Electronics Forum | Fri Feb 01 07:07:01 EST 2019 | dfl
Another semi-related question: are the four motion cards the same? (except for the dips, I guess). I have a spare one, marked as T motion, all dips to up position. Can I use as X or Y, if I match the dips? The boards look like to have the same comp
Electronics Forum | Fri Feb 01 07:11:07 EST 2019 | bobpan
x and y are the same...just change switches. t and z are the same...just change switches. The voltages on the cards are different(x/y same--t/z same)....i do have a procedure somewhere that allows you to make an x/y card into a t/z card. good luck
Electronics Forum | Fri Feb 01 07:21:32 EST 2019 | dfl
One of my 8mm feeders is blinking the red led after the pick-up. With both buttons the motor works as expected (forward/backward), but after the nozzle pick-up the motor moves forward and then the red led blinks. pressing the buttons the green led l
Electronics Forum | Sat Feb 02 09:53:49 EST 2019 | slthomas
Commponent pitch programming is performed via the buttons on the feeder. I don't remember enough to walk you through it but there are people here that do - I'm sure you'll get some help shortly. If not, go to http://www.precision-repairs and use th
Electronics Forum | Sun Feb 03 08:46:34 EST 2019 | dfl
SOLVED The LED/phototransistor was a little of the center on the "index wheel" (don't know a better name, its the gear that pulls the component strip). The wheel works with a LED from one side and a phototransistor from the other, through a hole on
Electronics Forum | Sun Feb 03 09:36:29 EST 2019 | bobpan
Good job.... Sorry i didnt see this post...some of us were busy snow tubing over the weekend...haha. Many times over the years....the rubber belt inside the feeder will deposit material inside. Sometimes it ends up on the sensors and blocks the ligh
Electronics Forum | Fri Aug 02 19:45:58 EDT 2019 | bobpan
haha....thanks Steve!!! Nozzle Height of 1 means that you have dust or something in the quadalign lens. You need to clean the lens with alcohol then a dry lint free cloth and if it stays the same....that means the lens has an issue or there is dirt
Electronics Forum | Tue Jul 21 20:39:42 EDT 2020 | jmelson
Yes, but they really only seem to be interested in dealing in PPM-refurbished Quad IV C machines. They will sell parts but don't seem to be very interested in supporting other models under the Quad label. (The QSA-30 was made by Samsung, but uses Q
Electronics Forum | Sat Jan 26 15:47:10 EST 2019 | dfl
I'm with an annoying problem with an IV-c. Almost all the time the Y-axis "stuck" when the machine is homing. The motor tries to move the axis but only make a sound. If I move the axis by hand it can complete the homing and then goes to the IDLE. So
Electronics Forum | Fri Aug 02 12:03:16 EDT 2019 | dfl
UPDATE: I was reading around about similar problems. My function #30 always return nozzle height 1. I tried to clean up the glasses and the internal laser lenses, no go, still at height 1. Even after removing both glasses, still at height 1. I saw s
