Electronics Forum | Thu May 01 12:28:56 EDT 2008 | petergog
what is the main concern about this reqirement? Why IPC-A-610c is revsised to this? IPC-A-610c said it is a defect.Solder touches the body of a plastic bodied component, eg SOICs and SOTs. But D version think it is acceptable. WHY? I thought "plasti
Electronics Forum | Mon May 05 13:40:28 EDT 2014 | rway
The vent is there for reasons as the name implies. It's a safety feature to prevent the cap from exploding if over-tasked. Yes, without the relief on the end, the caps have a potential to become missiles when they go. I had one go off when my hand
Electronics Forum | Thu Jun 29 12:07:09 EDT 2017 | georgetruitt
HOW THICK IS THE BOARD? IS THERE A LOT OF COPPER IN THE BOARD? DOES YOUR CUSTOMERS PROVIDE HEAT RELIEF IN THE BOARDS BARREL DESIGN THERE NEEDS TO BE PLENTY OF ROOM FOR LEADFREE SOLDER TO FLOW, DID YOU CHECK YOUR PIN(LEAD)TO HOLE (BARREL) RATIO? N
Electronics Forum | Tue Apr 10 02:57:53 EDT 2018 | rob
Yes I would, most of our old Yamaha machines (before 2005) will do 30-35 microns @ 3 sigma with the fine camera option. Our Jukis with His res camera's will hit it too. You should be OK with most things after 1997 with the right camera choice (whic
Electronics Forum | Wed Aug 08 21:18:15 EDT 2001 | davef
Get-out the razor blades, bud. You could run that sukka for 6 sec dwell, cook breakfast on it, and you still will not get fill. [Hole file that is, breakfast will go along ways if peckish, though.] You could fire-up the depleted ozone rework gun [
Electronics Forum | Wed Jun 03 21:25:33 EDT 1998 | John Allan
| Hello: | BACKGROUD: SMT components soldered on the top-side of boards that also require wave soldering have the potential to reflow during wave soldering. Reflowing these components during wave soldering is not good. It can cause cold joints, op
Electronics Forum | Thu Jun 04 08:32:21 EDT 1998 | Dave F
| | Hello: | | BACKGROUD: SMT components soldered on the top-side of boards that also require wave soldering have the potential to reflow during wave soldering. Reflowing these components during wave soldering is not good. It can cause cold joints
Electronics Forum | Fri Feb 11 10:14:54 EST 2000 | C.K.
Dave, to answer your questions, point-by-point: � Just out of curiosity, how are second side, skippy components oriented on the board with respect to the wave? The SMD's are all oriented in the "correct" direction with respect to wave direction(i
Electronics Forum | Thu Jun 22 11:42:29 EDT 2000 | Chrys Shea
Sal, Silly question: Were the parts skewed before they went into the oven? I've chased down a few similar reflow problems in my lifetime, only to find out it was a pick and place problem. Wrong nozzle size, bad nozzle, feeder not advancing all
Electronics Forum | Tue Nov 16 09:44:18 EST 1999 | - bobar
Ken, The technology you are referring to is also known as return-to-web. This panelization method involves a hard tooled perimeter die and a press equipped with an air cushion. The PCB circuit is punched out and then inserted or "pushed" back into
winsouce.jpg)
.gif)
