Electronics Forum | Tue Dec 01 23:24:34 EST 2015 | ttheis
Can anyone advise if the EXM-10A ethernet card is the correct model for a GSM1 machine vintage 1995 and which slot in the VME rack it should populate? Thanks
Electronics Forum | Fri May 24 03:24:14 EDT 2019 | weglimir
Thank you! it is the same on other slots as well, when I removed the board, error was the same, but it appeared instantly after DEK Program was loaded. When it is inserted - this error appears after 10 seconds (approximately) so it seems like somethi
Electronics Forum | Mon Oct 21 11:05:57 EDT 2019 | tey422
With the given update you provided, that would rule out the nozzle tool issue. If the parameter looks fine, then the issue would be somewhere around the nozzle tool bank. Need to check open and close release. If the nozzle seats flush "not tilted" w
Electronics Forum | Fri Nov 08 14:42:31 EST 2019 | rlising
Hi, wondering if anyone has encountered a magazine loader & magazines that hold 550mm in length. We are designing led strips and that is our longest config. All I have been able to find is 535mm with 50 slots. Any help would be appreciated. Than
Electronics Forum | Fri Nov 08 21:49:54 EST 2019 | elsey1987
hi How about this type? 630*530*570mm with 50slots How many pcs you may need
Electronics Forum | Wed Jan 27 13:26:26 EST 2021 | dontfeedphils
Something like this? https://jnaindustries.com/stencil-frame-shelf-36-5-16-zigzag-center-55-slot.html
Electronics Forum | Tue Aug 16 06:20:34 EDT 2022 | bukas
it can be a bad contact with backboard. clean the slot and gold fingers with contact cleaner and push it in and out a few times.
Electronics Forum | Sun Sep 18 06:31:23 EDT 2022 | dilogic
It can also be a faulty servo controller (not the amplifier), I think it's UMC3 board in slot 10
Electronics Forum | Mon Dec 12 09:02:30 EST 2022 | peterm
You teach the corners of the component picked from the previous steps. Just select "PTF RR BTWN RAIL" slot 75 in "feeder teach" and it should move over to the belt.
Electronics Forum | Thu Jul 18 11:38:18 EDT 2024 | babe7362000
I am trying to figure out why the stacker goes up when you press the dump button. Then I have to lower it by hand to rehome. It then will rehome and go to where it needs to on the 1st slot.