Electronics Forum | Thu Dec 10 22:36:03 EST 2020 | solderingpro
I represent PROMATION USA and we have several solutions for solder wire perforation: Our QUICK 372B is a stand-alone drilling station. Our QUICK 371DI is a semi-automatic hand soldering station with perforation technology. Our QUICK 300A/B is a d
Electronics Forum | Thu Aug 08 22:22:05 EDT 2019 | sssamw
Did you solved this issue? I would recommend you track online station by station, until you detected the solder bridge, so you can narrow down the analysis scope and focus on potential causes.
Electronics Forum | Tue Jan 22 22:38:57 EST 2008 | davef
A minimal ventilation rate of 0.05 cfm per square foot, the recommendation of the 1998 International Mechanical Code. However, this may not take into account other potential building contaminants from such sources as propane forklifts, which require
Electronics Forum | Fri Apr 05 08:02:58 EDT 2019 | Matt
This feedback is greatly appreciated! I had my reservations on the connection validation features, as you said good in theory but I really wanted some practical information without having to purchase to get an extended feel on our various application
Electronics Forum | Mon Apr 26 23:24:44 EDT 1999 | D Clement
Which is the preferred method for soldering a bga, adding solder paste or not? Solderpaste manufacturers say to add solder while the rework station manufacturer's say it's not necessary.
Electronics Forum | Fri May 12 07:53:40 EDT 2006 | egrice1
Sheldon, Tip life is directly related to temperature, IRON plating thickness on the tip, Alloy composition used and operator technique. High tin contents in lead free alloys attach the tips. Poor wetting and higher melting temperatures cause us
Electronics Forum | Wed Oct 12 12:33:11 EDT 2005 | Inds
Hi Everyone, I am trying to site dress PTH holes filled with Nihon solder mixed with SAC solder at the rework station. But what i am seeing is the solder just doesn't melt and I am not able to suck the solder out of the PTH. Has anyone faced this i
Electronics Forum | Wed Feb 08 20:05:16 EST 2006 | gcolbert
My company was considering buying RV-2E/s to perform functions in a electronic circuit board manufacturing facility. Are they any obvious situations where this machine can be used? Soldering/labeling/station transfer/general assembly? Any suggestions
Electronics Forum | Mon Jul 14 10:17:27 EDT 2008 | dwelch123
Ed,,You need a temp gauge to verify tip temp and if it's a digital control iron and it's off usually just junk it. If dial control you can loosen knob and adjust to reading.If you need to know type of gauge and manufacturer drop me a line
Electronics Forum | Mon Jul 14 11:33:35 EDT 2008 | stepheniii
It depends on the type of iron. Some of ours have a little plug you pull out that exposes a pot that you tweak to make the temperature of the tip the same as the reading. Others can't be adjusted and the heating element must be replaced if they don't
