Electronics Forum | Fri Apr 30 08:28:39 EDT 2004 | davef
Roger Saunders, President Saunders Technology, Inc wrote a fairly unbiased paper that compared different thermocouple attach methods. You can probably find it on their site. In it, about gluing thermocouples, he says: There are two general classes
Electronics Forum | Thu Jan 03 17:00:20 EST 2008 | davef
Recommended procedure for soldering stainless steel [Atlas Steels Australia]: * Surfaces must be clean and free of oxidation. * A rough surface improves adherence of the solder, so roughening with grinding wheel, file or coarse abrasive paper is reco
Electronics Forum | Wed Nov 30 12:44:54 EST 2005 | ppwlee
Dave, Do you know if such thermal transfer study with CB-100 (or equivalent) is available for review? My customer is pursuing this option and I am curious on how much improvement I would see by specifying a conductive via fill on the board. Rgds, P
Electronics Forum | Mon Jun 07 10:57:31 EDT 1999 | Dave F
| | | | Where I can find some informations about repairing of SMT boards? | | | | | | | | Thanks | | | | | | | | Marcos | | | | | | | A first place to start is IPC's 7711 and 7721 encompasing repair, modification, and rework procedures. | | | |
Electronics Forum | Tue Jul 05 13:54:35 EDT 2005 | Sandeep
We are facing lot of problems with tombstoning in 0201 components. Ironically tomstoning in these components is not occuring while reflow but it is happening when we subject them to thermal cycling test. We have been investigating the cause and thoug
Electronics Forum | Sat Jun 11 07:51:15 EDT 2016 | davef
Hi Steve ... There are arguments between fabricators and thermal relievers about adding non-connected copper tabs to barrels in hopes of providing thermal relief, but that's not what you're talking about, I believe. I don't foresee an issue moving t
Electronics Forum | Wed May 19 10:48:40 EDT 1999 | Glenn Robertson
| | | We are currently looking at purchasing some BGA rework equipment. Could someone give us the pro's and cons of IR heating (top/bottom)vs. hot air convection ? | | | All other tips are also welcome. | | | | | | Thanks | | | | | Philip, | | I ha
Electronics Forum | Tue Jun 01 19:35:39 EDT 2004 | Ken
There are studies out there that looked at gold embrittlement. The overall consensus is to not exceed 5% by weight. As far as the conductivity question, as themo/mechanical creep fatigue sets in, your conductivity will be affected as the joint is s
Electronics Forum | Tue Sep 19 14:40:13 EDT 2000 | Erick Russell
It is always a good idea to heat the entire board to 100C to 140C prior to reflowing the site to be reworked to reduce warp and localized stress. (Thermal uniformity of the preheater is key here). For a BGA, the laser is programmed to heat only the
Electronics Forum | Thu Oct 25 11:29:04 EDT 2007 | ck_the_flip
Forget all the bickering and semantics. EVERYONE IS RIGHT!! ...but then again, in soldering, there IS no right, wrong, or indifferent... just blame. :-) Soldering is, after all, the most difficult process with the most opportunities for defects.