Electronics Forum | Fri Sep 13 13:43:48 EDT 2002 | barryg
You right Simon, this forum is not for that type of question, but since you have been polite and desperate, i'll shoot some help. Your right, sounds like it is the unit, there is probably a component failed that is shutting down the unit when it gets
Electronics Forum | Thu Nov 11 02:59:03 EST 2004 | Base
Hi Charlie, In case you're processing large quantities of lumileds you may want to have a look at the Assembleon FS machine. It is an FCM machine of only half the length with some dedicated robots on it. In stead of all Pick&Place robots it 2 dispen
Electronics Forum | Thu Jan 27 11:33:59 EST 2005 | russ
For what you have right now I would recommend that you use soldering iron tips that are made for component removal. until you get BGAs I wouldn't worry a whole lot about the expensive rework equipment. I would use specialty tips and a heat gun wit
Electronics Forum | Tue Sep 12 16:49:56 EDT 2006 | Brad Courtemanche
Good Afternoon, I'm am probably asking a question that has been answered a million times but I am looking for other operators and process engineer feedback on the slim kic 2000 profiling unit. I have played with the unit several times and am not to s
Electronics Forum | Fri Sep 07 09:13:21 EDT 2007 | smtirl
Folks, we've recently upgraded to Heller MKIII reflow ovens with Gen 9 cooling units. We're running N2 atmosphere at 1000ppm O2 and Kester256 solder paste. We're seeing a big problem with flux residues building up in the cooling section of the
Electronics Forum | Tue May 13 08:57:19 EDT 2008 | locostpp
It will be rigid, but not as rigid as something weighing 600lb's. We can't afford to cast/machine parts for a low cost machine. But we think have found techniques that can calibrate out any small distortions in the unit. Your comment about a decen
Electronics Forum | Sat Feb 06 15:47:01 EST 2021 | mendez
Hello, I'm new to this forum. I recently purchased a 100MV Screen printer and unfortunately; it arrived damaged. I was able to turn the unit on and I was able to get the unit do the initiation process (ex. datums). When I tried to do a sample PRIN
Electronics Forum | Tue Mar 07 11:00:17 EST 2000 | John Luckham
I am looking for information concerning desiccator cabinets, could anyone help.
Electronics Forum | Thu Jul 13 18:17:33 EDT 2000 | larrys
Is using a refridgerator for storage an option?
Electronics Forum | Tue Oct 17 10:53:10 EDT 2000 | Rick James
Regarding your comments about the EASi Line - a robotic workcell was planned but the company determined they were spread too thin to support the effort about 8 weeks before the show. It was too late for a replacement. The manual assembly operation