Electronics Forum | Thu Sep 03 21:49:20 EDT 2020 | kylehunter
> Not in our case, the pre-heat temp was not high > enough. Also our pre-heat is only from top > (KISS104). Ahh that makes total sense. We have bottom IR, and have thermocoupled at 100c, so I think we should be good on that end. Anoth
Electronics Forum | Mon Aug 31 14:45:37 EDT 2020 | SMTA-64387994
Can anyone provide any insight to an appropriate way to apply a Gage R&R study to an x-ray inspection machine? We have a Vitrox V810 S2EX machine that we would like to perform a measurement system analysis on. What methods do you use? Which type of G
Electronics Forum | Sun Sep 06 03:24:31 EDT 2020 | rsatmech
Hi All, We are frequently getting tombstone in an induction component. (0102) There is no paste offset or placement offset. PCB pad design is not as per recommendation. Stencil opening is 1:1 Same part used in two locations and both the locati
Electronics Forum | Tue Sep 08 15:12:56 EDT 2020 | cyber_wolf
I concur with Spoilt on all accounts. If the tombstones are isolated to the same P/N this is an indicator that your process is probably not to blame. At this point you have to try and mitigate the issue. Things to try [if possible] : 1. Try a soa
Electronics Forum | Sat Sep 12 02:16:41 EDT 2020 | jmelson
Arrgh, that's an SFA-410ED camera, original subject was wrong. Hello, the down camera on my Quad QSA-30 has gone haywire. It still puts out video, but does not sync to the vision system, the picture rolls horizontally. I have verified the vision int
Electronics Forum | Wed Sep 30 20:35:51 EDT 2020 | erici
Hi all, was wondering if you have any ideas on how to correct the problem we are encountering with our S25 machine. The machine is giving an X-axis counting error at gantry 1. I replaced the x-axis linear reader and the linear scale as well, but st
Electronics Forum | Tue Oct 06 17:36:20 EDT 2020 | hearsehauler
Have used stencils for low volume paste printing for 18 yrs. New job uses jet printing (MY500). But machine is limited to .33mm dot size. Parts used here have pad sizes that are .25mm or smaller, so paste touches between pads when printed. Thankfully
Electronics Forum | Sat Oct 10 12:14:45 EDT 2020 | krishna7185
I woud like to ask is there any command in Alitum Designer 17.0 which will help to group component circuit wise while we provide netlist to pcb from schematic. Actually i have single page schematic with many circuits on it block wise like GPS, RF, Po
Electronics Forum | Thu Nov 19 11:50:18 EST 2020 | aurash
Sarason - I can do that (did before) but you need an exact HDD model for the transplant which challenging to find (10 Years old) - but I appreciate your answer. I got an old HDD (from another machine) and made a mirror on a brand new one and fitted
Electronics Forum | Fri Nov 13 19:24:33 EST 2020 | jmedernach
Dress From -> Dress To -> To "From" and "To" are pretty obvious but I have no idea what "Dress From" and "Dress To" mean. The wiring list is presented as a grid. Each of the categories above are represented as columns. Every row is a "run list."
